Hi, inside the SLDZ have a transparent plastic disc with some marks. I need this part .Can you help me.Thanks

Hi. Inside the printer and behind the print head there is a small transparent plastic stripe . Check if it is dirty.

No , I dont have any firmfare update for sldz 1200. as soon as I found it , I"ll contact you. thank you

Hi,
firstly dismantle the printer so you can clean the timing disk wich is located inside printer on leftsideway, also clean the plastic transparent tape wich is vissible when you open the ink cover.

Had the same problem. By lid I assume you mean transparency unit. To fix, it is necessary to remove the transparency unit from the scanner. Then IN A CLEAN AREA! with the glass side up unscrew the 6?screws that hold the top unit together. There will be a hinge assembly inside. You must remove it, clean it, and re grease it thoroughly. I used lithium grease from an aerosol can. Has not given me problem since. the whole process took about a half hour. just make sure you are gentle, and keep everything clean.

Somewhere, your printer has a sensor (probably a light and a mirror and a detector), to try to distinguish between transparency media and opaque media (such as a sheet of paper).

So, that sensor either has a piece of transparency media stuck inside it, or it is otherwise misdiagnosing what media is between the light-emitter and the light-detector, and thus is claiming that there is transparency media loaded into the paper-tray.

It sounds like you need to take the printer to a qualified technician.

wanna sell it?

hii,
try to clean film stripe between the carriage(transparent plastic)

body { background: #FFFFFF; margin: 0px; padding: 4px; font-family: arial, verdana, sans-serif; font-size: 10pt; } p { margin:0px; padding:0px; } .spwrap { background: transparent url(../wysiwyg_rte/misspell.gif) repeat-x scroll center bottom; } That program that you have screen shot is not malwarebytes, there's really something inside that computer that is creating this problem.. try to disconnect the computer and redownload malwarebytes then install it again and after installing it disconnect the computer from the internet...

Hi i have had a few cd's/DVD's repaired by blockbuster, they charge about 2 to 3 GBP and so far i have had no problems.

this works by removing a layer of plastic from the disc.

if this fails then it my be worth getting your unit serviced as the fans puill in a lot of dust from inside the car..


Mark
www.carradiospares.co.uk
www.blueice-electronics.co.uk

Save the images as png24 in photoshop and make sure transparency is checked and then use them in Ulead, it should work!