How do i fit a door seal on a zanussi 1421W washing machine please

Please check this link below:

http://www.espares.co.uk/advice/washing-machines/a/7/1394/how-to-replace-the-door-seal-on-a-washing-mac.html

Please look into a visual demo for changing the door seal:

http://www.espares.co.uk/advice/washing-machines/a/7/1397/how-to-replace-the-door-seal-on-a-washing-mac.html

Hello,you mean you have a door gasket. A good, step-by-step article on this pesky concept of "panel-screw" gasket installation is found on this handy page:

http://yourhandymanzone.com/Your_Handyman_Zone_How_To_Pages_Appliance_Zone_Refrigerator_Install

Thanks

its a9/10 job if you good 'diy if not call tech..should take around 10 mins for tech to fit....cost of seal £30 GBP....please leave feed back

it is very very difficult to replace the door seal on a zanussi washing machine, its best fitted by an engineer

Fit the seal first and then fit the spring,it cannot be done with the spring fitted on the seal first.
Plz rate my solution.
Thanks.

the holes in the roof of the container are blocked. try pusing a piece of wire up there. if not fit a new container.

the only way to fit door rubber to tub on a zanussi is to use washing up liquid it takes two mins

most likely caquse is door interlock. only way for you to test is to substitute

unplug machine. Pull off retainer clip from the front , with both hands inside push up the seal untill its free. Then with the new seal apply washing up liquid to the gap on the seal. And fit this is fiddly. Then pull the spring you removed to loosen abit and with a screw driver to keep it in place throught the door lock thats why youve unpluged it. strech the spring around. the ease on the front part of the seal and replace the clip. put on a wool wash to check for leaks. appliance doctor