How to reset drum counter for fuji xerox 203A

If all the lights are blinking on your Fuji Xerox 203A printer, it is indicating a "Fatal Error" or "Unknown Error" that has occurred.
Here are some possible reasons and troubleshooting steps you can try:

1. Paper jam - Open the printer cover and check for any paper jams. If found, clear the jam and close the cover.
2. Toner cartridge issue - Remove the toner cartridge and check if it is empty or low. If so, replace the toner cartridge with a new one.
3. Imaging drum issue - Remove the imaging drum and check if it is damaged or has reached the end of its life. If so, replace the imaging drum.
4. Connectivity issue - Check the printer connections to ensure they are securely plugged in.
5. Firmware issue - Try updating the firmware on the printer to see if that resolves the issue.

If none of these steps solve the issue, you may need to contact Fuji Xerox customer support for further assistance.

When the drum is replaced the counter on the DP-C264 automatically resets. If it does not reset then the flag on the back of the drum has been damaged in shipment or during the install of the drum.

Try this link:
Compatible Fuji Xerox DocuPrint CWAA0648 Drum Unit
Fuji Xerox DocuPrint CWAA0648 Drum Unit

Press the button until all the lights are on..then let go the button, this will reset your drum counter.

the drum or toner LED? if it's the drum, then just press the button until all the LED are ON then let go and this will reset the drum..
if it's toner, you need to take out the toner and on the left side of the toner, there is a level, unscrew the 3 screws and turn the level to the other side, re screw the whole cover and install back to the printer, this will reset your toner, make sure there is toner in the cart.

take out the drum unit and clean it, normally when the drum unit is dirty with toner, it will give you error.

You get it 90-100 US dollar for any Fuji xerox sale center.

refer my other posting on how to reset the toner.
left side of the toner cartrige, unscrew and turn the level other side.

pls replace the sensor in the printer and also chk after replacing a new toner

Managed to get it going ,pulled all the toner cartridge out and reset and all is sweet.....!