On a kx-ta1232 key system we are trying to run a single line phone for an extenstion to a shop that is 3400 ft away. The line is bridged in the CO. When it is bridged you hear a buzz in the background but if you put dial tone going either way from CO it is quiet. Any ideas?

There is a reset code for each handset which I believe is 790,

On the cabinet, there is a jack marked EXT MUSIC. You plug in an audio source to the jack and then go into system programming and turn it on in program 111.

Carl

You need to cancel absent message on your phone. The method depends on which Panasonic phone system your phone is connected to. Following are the methods for three different Panasonic phone systems. Once you cancel absent message, your screen should return to date and time, if not then press * until it does.

KX-TA624 Phone System
Press intercom button, dial 750#, lift handset then return handset to cradle to end.

KX-TA1232 Phone System
Press intercom button, dial 7500, lift hanset then return hansdset to cradle to end.

KX-TDA100 or KX-TDA200 Phone Systems
Press intercom button, dial *7500, lift handset then return handset to cradle to end.

A Panasonic Analog PTS ring sound is not adjustable, however, the cadence is. An outside call rings with a single ring, an internal call is either voice announce or a double ring. The digital phones from Panasonic have either 8 or 30 different tones, but that's a different system.

Carl

hi i need schematic diagram motorola gp-98
pleas send me
thank you

To program a key for an appearence of an extension, press feature 00, press the key you want to program the extension number to, then press the right intercom and the extension number. press 00 when finished

Panasonic KX t7730 call forwarding function to external party:
If you are using the Kx-TA624 pbx (TES 824 models) system, program your phone unit (t7730) as follows: lifet handset, press FWD/DND button, press 3, then the outside line access code, then phone number, then #, then return handset.
If you are using the kx-ta1232 (higher models) of pbx system (usually with 9 or more CO lines cabable, use the following command:
lift handset, press FWD/DND button, press 6, then the outside line access code, then telehone number, then # then return handset to cradle.

You can purchase a manual for about 10 dollars
Email your system/phone model number to sales at aaa-avad.com for further instructions.

Also, are there certain CO lines that can only work with this KX-T61610 system? Typical FXS? or any odd analog settings on CO lines or within the Key controller for the KX-T61610?

Depending on your model system, it may or may not be possible. I included the two different methods to change the ring tone below depending on your system. Give it a try.

KX-TDA Systems
KX-TD Systems
Press PROGRAM
Program Press the CO Line key you wish to change
Press the same key again, enter the tone number (01 through 30)
You will hear the tone associated with the tone type number. For example, if you press 02, you will hear the tone associated with tone type 22. Press each number (01-30) until you hear the tone you desire.
Press STORE
The tone is now stored for that line on that phone only.
Press PROGRAM 99 (or PAUSE 99 if you do not have a PROGRAM button
Press the CO Line key you wish to change
Press the same key again, enter the tone number (1 through 8)
You will hear the tone associated with the tone type number. For example, if you press 2, you will hear the tone associated with tone type 2. Press each number (1-8) until you hear the tone you desire.
Press STORE
The tone is now stored for that line on that phone only.