It won't take my pressure anymore it gives me an

Maybe she shouldn't call you anymore? Lol j/k. Contact your provider or apple and they should fix this for you

Are you getting an error message or any other indication from the camera? Have you checked the memory card to see whether it's write-protected? What exposure mode(s)? What shutter release mode(s)?

Here is the complete service manual for your unit.

Each cartridge having printing life, as long as cartridge health condition is good it won't gives any trouble. Subjected series printer having mono & colour cartridges,1. Remove both cartridge from the printer 2. Switch on & wait till message appears for insert the cartridges..3. Insert mono(Black) cartridge, close the door & wait till message appears on screen. If message appears same as cartridge error mean that mono cartridge is faulty replace it, if message appears like insert another cartridge, it's confirmed that colour cartridge faulty.. Replace it..

Time for a new camera.

1st of all you should always have a good (not free since we all know what you get for free now-a-days) antivirus software no matter what you're doing with the computer, especially if you're connected to the internet! The first thing to do is borrow another computer or have a friend come over to test your connection if they aren't having the same issue.
As for the intermittent problem it could be one of three issues. Your router may be giving up the ghost (failing lol) and needs to be replaced, or the modem is failing (try unplugging it, wait about 30 seconds then plug it back in), or the ISP may be having issues on a section of their line(s) and they aren't aware of it. Borrow a router you know works fine and see if that solves the problem. If not then call your ISP to see if they know of any issues in your area and have them start a repair order to check out your problem (most ISP's won't charge to do this). Good luck

I have the same problem. Everything on the printer is working just fine. It'll do a test page just fine, so everything's working right. The %$^ thing just won't print. It makes noise like it's printing when you give it a print job, but it spits out blank pages.

E27 means there is a problem with the door lock. Unplug the machine for 5 minutes and try again. If the error code returns you will need to replace the door lock assembly.


If you have anymore questions please comment me back.

Turn the machine off first and unplug.

If you've got a manual, look up the page for trouble shooting, this error message may be listed iwth a solution. I'd also suggest that you remove and clean out the bobbin holder. This is the little black piece you put the bobbin into. It has possibly dislodged if you've had a jam up. You will need to unscrew the two screws holding the needle plate down, take out the needle and pressure foot to give yourself some room too. Put the bobbin holder back into position lining up the red markings on the holder and the stopper, your manual should show images of this.


Once its all back together, turn on and hopefully it will reset to normal mode.
If you've done all this and the error message won't stop showing, then yes, you'll need to take it in for a service.

The best advice that anyone can offered to you, is to do what the error message tells you to do. Follow the instructions and call the number. It's the Customer Care Dept of RS Medical, the manufacturer of your product, which oddly enough isn't a Blood Pressure Monitor. Since it's a toll free number, it won't cost you anything.