When i refil a new ink printer after i close it cannot print, black cartridge missing, so how i solve it.

Unplug the printer from the wall. Now remove the power brick from the back of the printer for 60 seconds. Plug everything back in. This will reset any error messages the printer has.

Power on the printer. Open the printer and take out the Dell Series 5 Black cartridge. make sure all the tape is off the cartridge and put the cartridge back in. Now do the same for the Dell Series 5 color cartridge.

Close the printer. It should print an alignment page. Any error messages?

Black cartridge = black side(left side) color cartridge = color side(right side)

Photo cartridge = black side(left side) color cartridge = color side(right side)

Dell Series 5 ink cartridges have a sensor in them that cannot be reset. Article on refilling Dell ink cartridges.

Dell Series 5 ink cartridges can be purchased at Staples, Walmart or Dell's Website.

If these ink cartridges are new, then take them to the place of purchase for a refund or replacements. If they're old, then try purchasing a new Dell Series 5 ink cartridge.


Rick

Ink is a lubricant for the print heads. Some color ink is used even if you only print in black or vice-versa. If you printed with black ink missing, you could destroy that print head from the friction of running without ink to lubricate it. That's why most printers won't allow you to print with black ink missing even if you aren't using it. That's the case with your Canon printer.

If you allow a color to go empty, the residual ink in the head could clog and become permanently blocked. You would never be able to print that color again. So always replace ink cartridges as soon as they are empty.

Your black printhead is blocked.
The printhead is deep inside the printer and has to be taken out by the expert and cleaned with the help of 'steam' and hot water. This is because not using the printer for a long time. or using low grade refill inks.
Please select new cartridge only if you are inserting a new cartridge or fully refilled cartridge. Otherwise use old cartridge option. Brother printer has a mechanical sensor and not the electronic chip in the ink cartridges.
After inserting the old used cartridge if you choose 'new cart' option it will show the "Full" ink. You can still print from the exhausted ink cart after covering the sensor in the middle by a piece of paper in emergency.

i've quite come across this kind of problems many times. Simply replace your cartridge with new ones or try that old one to dip its head in the hot water for sometime.

Are they new cartridges?

If so, have you removed the clear plastic protection strips from the cartridge heads?

Well, I'm sorry but the printer folks all hold us up on the ink cartridge rip off! Nothing you can do but buy the cartridge and pay the price. But you may be able to refill it, I've had some luck in this department but it's far better to just buy one. The machine won't continue to print with just the black cartridge...it uses some color ink to print a black and white copy. I really don't understand why someone can't build a sturdy printer with refillable ink that will operate for pennies and be make of metal so it won't break....! You might look around at some of the stores will sell you a new printer with ink for about the price of the cartridge.

“Lexmark does not support the refilling of its ink cartridges. Refilling the ink cartridges can cause them to leak, thus clogging or even damaging the print head. Any damage to your printer caused by refilled ink cartridges may not be covered under warranty”. Please use genuine Lexmark cartridges for best results.

Hi, sounds like a dodgy ink cartridge. I would purchase a new black cartridge and fit and try that. Refilling epson cartridges isn't a good idea, if you can't afford originals, but compats instead of refilling them. a good place to buy is www.choicestationery.com I've never had any problems with their carts.

Buy, and refill #34 cart. for black, and click close, then continue on the pop ups, and it will print.

I have the same problem. According to another site I visited you will not be able to solve your problem by refilling the 28 cartridge (black ink). You will need to purchase a 28A ink cartridge which is refillable.