Turntable motor - Sanyo Microwave Model EM-S8000W

If you wish to get some details about repairing microwave oven then check the below added link.
http://electro-medical.blogspot.com/

Sanyo EM-P672W Microwave Oven Repair Questions ...

www.fixya.com > Forum > Microwave Ovens > Sanyo
Recent Sanyo EM-P672W Microwave Oven questions, problems & answers. ... Mysanyo super shower microwave wave stopped working it shows on the display to press clock key but ... What would cause my Sanyo Microwave to not heat up?

Sanyo EM-P672W Microwave Oven Sanyo microwave fuse ...

call ser. tch. ur motor might be spoiled already . its a added function mabe of the unit if ur turntable motor not wroking so does ur microwave

It does have a line fuse. This link should help you identify the location and replacement. http://www.appliancepartspros.com/partsearch/model.aspx?model_id=208280. Hope this helps you.

Check with www.microwaveglasstrays.com (Martin Microwave Inc.) 1-877-894-0035

The original replacement tray (Sharp part # NTNT-0048MRF0) has been out of production for years and nothing else will fit, however, Martin may have a used replacement. If they don't have it, no one will!

Remove the turntable plate and check the motor coupling gears underneath, if motor coupling is fine, then replace the turntable motor.

Enter the model number on one of two websites below to get parts and diagrams for your appliance:


Appliance Parts From PartSelect

Appliance Parts Pros

Well the table might not be on the revolving piece- that is what happened to my microwave oven, or the revolving piece might have to be connected to a belt inside that turns it

Please do not operate the microwave (other than short bursts when testing) until the cooling fan is working again.

Otherwise, the magnetron will be destroyed, and that's expensive.

When the magnetron overheats (since the cooling fan is not working) the magnetron thermostat opens up to kill power and protect the magnetron until it cools back down again.

Chances are you have a bad connection, bad relay, or bad component driving the relay on the control circuit board.

If you will scan (at 300dpi if possible) the schematic, and e-mail it to me, along with clear digital photos of both sides of the board, I can probably help you get this fixed.

Feel free to contact me directly (and please remind me of your full model number).

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

William E. Miller
[email protected]
http://www.microwavedisplay.com

The turntable system consists of the motor, the coupler, the turntable support with rollers, and the tray.

You can see and hear a video of how a turntable motor should sound when you rotate it by hand.

If yours is not set to be off via the control panel, and it won't rotate or it sounds like it's grinding, etc., you may have a bad motor or plastic coupler.

To replace either, you need to unplug power, then remove the bottom cover of the oven. In some brands, you have to cut the motor cover off with snips, then use a screw when reassembling it.

You can find Sanyo UK support, parts and authorized servicers here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

I have the exact microwave you do (ems8000w), the motor failed and I found this one worked perfectly as a replacement.

The original is impossible to find.

https://microwaveglasstrays.com

1 x 120v Microwave Turntable Motor 6RPM 4W # F63265G60AP (F63265G60AP) = $14.99
Good luck.