I have a barbie house form the early 90s possibly 1993 i have no idea what it is called. its comes in several parts that slot together to assemble floors walls and dividing walls. it has white fencing and is all pink two story and im sure comes with a stable but this may have been purchesed seperatly can you help?

2 possible answers
hydraulic washers in use have a steel surround with a rubber insert which acts a a seal
the rubber seals off and the steel stops hydraulic pressure from pushing it out of place
or the there is a crack in the thread where the hex nut is
get a new washer from a hydraulic shop and if that doesn't fix it, you may have to get a new valve body
discuss the problem when you are at the hydraulic shop for more ideas

barbie dream house replacement parts can be found on amazon, click here and take a look: Amazon com barbie dream house parts. I hope this was helpful. Cheers

contact mattel. heres the customer service number Mattel, Inc.
333 Continental Boulevard
El Segundo, CA 90245-5012
310-252-2000 tel

Remove the the bulb and check the holder for corrosion and take a small screw driver and bend the leads closer together. Also check the leads on the outside part, that they are not flattened out, again bend them up.. And check the plug that goes to the housing for corrosion and if neessary bend the clips a little closer together.

The part number really means nothing as there is no more Saturn. Call a parts store and tell them what you want, or look it up on their website. They will have an inventory part number for it and the company that makes them will have their own part number also. It will be a common GM early 90s part.

Most early 90s GM trucks have the fuel filter mounted on the inside of the drivers side frame rail about the area of the drivers door. If it's not found there look on both inner frame rails, it will be on one of them between the front and rear tires.

The part is called the wheel cylinder. (Not to be confused with the master brake cylinder that is under the hood and provides the pressure for the brakes to operate.

On a 1993, I suspect you have drum brakes, so the part you are describing as a rotor, (and that looks, well, round like a rotor), is actually not called a rotor. That is reserved to describe the round heavy plate on the front wheels.

Newer cars actually would possible have disc brakes with rotors on the front and rear wheels.

More than likely, especially on a 1993 vehicle, the seals in the wheel cyclinder are shot. Not sure how hard it is to get replacement parts, but the same re-build kits would likely have been used on several years and models of GM cars from the early to mid-90s.

You can find a copy of the instructions on ebay for $5. Otherwise, its not impossible to figure it out without them. There are also spare parts on ebay, or you can buy a second house, make one complete one and sell one off for parts.

Mattel products, including Hot Wheels, Barbie and Polly Pocket:
In the US and Canada: 800-524-8697

Could not find a picture of this installed, I have replaced this spring and it is hard to do. You have to put the straight prong of the spring unto the valve arm, you will see a spot for it to be at, then wind the other end of the spring around until it goes into a slot, then get it all together on the agi housing before it comes apart. Hope this makes sense.