I would like to WIFI my phone but have forgotten the password on my Belkin how do I find it or reset it.

There is no way we can know your password.

If this is a Belkin N300 router the default username and password will be the following :

Username: admin

With one of the following passwords :

Password: password
Alt. Password: 1234
Alt. Password: 12345

If you have ever changed the username/password and have forgotten them, you can reset to default by following below procedure (This will reset all settings to factory defaults) :

Press and hold the "Reset" button for at least 10 seconds, and then release it. The lights on the Router will momentarily flash. The "Router" light will begin to blink. When the "Router" light becomes solid again, the restore is complete.

http://community.belkin.com/t5/Wireless/how-do-I-change-my-password-on-my-belkin-N600-db-model-f9k1102v3/td-p/6997

I’m happy to help further over the phone at https://www.6ya.com/expert/donald_f2ed37026a3ac881

I am pretty sure it will be the same as my Belkin WiFi router. Just unplug the power cable wait about a minute then some where on the router will be a small hole that says reset on it, usually on back near the cable connections. Take a tooth pick, straightened paper clip or something similar and push it in the reset hole, you will feel and hear a small click as you are depressing a micro switch. Hold the reset switch down for 15 to 20 seconds and reinstall power it should reboot in default or factory setup with no password.

If you have forgotten the password, reset the Belkin by pushing and holding the reset button for 30 seconds or so and release, this will reset to default settings. Connect and reconfigure the SSID and Security Key. You may want to write down the password and store for future use. Belkin Support: http://www.belkin.com/us/support-article?rnId=6939

Are you trying to login and change the wireless settings?
If you have forgotten the login password you can RESET the Belkin back to the factory defaults and configure it again.
THEN
Power up the Belkin and press the RESET button for 7 secs.
The default login password is blank.

hey what you can do is you can reset the entire router... by using the reset button on your belkin router... Or else you can also access the router by using the following IP address in the internet exlorer...

try 192.168.1.1 or 192.168.1.0 & then go to the wep settings & reset the router or change the password for the router...

If you dont know the password or have forgotten it, just remove the power and hold the reset in under the bottom of the unit in, reconnect the power and count for 7 sec. lights will flash and the password will be default again. It resets it back to factory settings.