Getting code F3 and not draining ?? - Whirlpool Duet GHW9150P Front Load Washer

The F3E2 Error Code indicates that there may be an issue with the Temperature Control sensor. Try resetting the washer/dryer by unplugging it from the outlet for at least 1 minute, and then plugging it back in.
Another issue is a blockage in the outlet drain pipe or pump.

Amana Appliance Fault Codes - PartSelect

www.partselect.com/JustForFun/Amana-Appliance-Fault-Codes.aspx

Fault codes for Amana ovens, range, stoves including dual convection wall overs and 'big ovens'. ... F3-1 - Oven Temperature Sensor/Circuit Failure - Check wire connections and ... what does it mean when the oven turns off and f3 shows ... My Amanaagds902ww gas range flashes "Door" when attempting to light the oven.

Amana Gas oven Fault Code F3 - Appliance Repair Forum

forum.appliancepartspros.com/oven...ranges-cooktops/143114-amana-g...

Nov 17, 2010 - 2 posts - ‎1 author
Have a Fault Code F3 display on oven when trying to set oven ON. Researched ... Yes, your F3 code would indicate a sensor circuit problem, Jenn-Air Electric Range Code F3
4 posts
Mar 15, 2011
Range keeps giving error codes E0/F3 and E4/F3 and the ...
5 posts
Nov 22, 2010
Replaced Sensor Still Getting F3 Error
4 posts
Sep 20, 2008
F3 Error code on whirlpool Range
4 posts
Sep 10, 2007
More results from forum.appliancepartspros.com

Amana Fault Codes - Appliance Help O

Product Solutions Laundry Solutions Washing Machine

I just had the same problem with my MayTag washing machine - F3 & E2 error codes.
I cleaned out the drain trap then proceeded to remove the top and rear panels to check the Temperature Sensor. The sensor was tested with an Ohms meter and found to be working properly.
I went over the wiring from the Temp Sensor and found that both black wires had been 'cut' under one of the zip ties near the bottom of the washer.
I had to reconnect them with marretts and presto; the washer works perfectly again. If you encounter this same problem - be diligent in going over the wiring. I missed it the first time around.
It's an easy fix for anyone who can strip a wire of the plastic coating.
Good luck :)

Yep F3 I dont even have to look that up fault with oven tempreture sensor. If you perform an ohms test on it at room tempreture should read between 1000-1100 ohms if less then replace. Thanks again
Rick

The F3 - E0 means Oven temperature sensor (RTD) opened (upper oven, if double oven) Replace Oven temperature sensor (RTD)

Note: Applies to all F3-E... codes.

F3 means open ven temperature circuit you will likely need to replace the oven sensor.

i got my morofone f3 unlocked by doing some research online an getting some free ulock codes,

eventually got it unlocked

thanks anyway,,, get in touch if u nee to know more on this subject

f1 error code is a defective touch pad or control board.. the f3 error is a shorted temp sensor.. you might be better off just getting a new oven. check on price of parts first.

I keep getting an error code of F3 for my Magic Chef stove model CER3520AAL does anyone know what that means and how to fix it?

Help!!!