Pls send me solutıon..for lens error
ı switched on machine "lens error" why
You can disassemble the lens and clean the dust. Here are some photos of the disassembled P2 Lens http://fixit.limewebs.com/p2/
Lens error = Lens damage
The opening closing mechanism has failed because of dirt ingress or damaged caused by a knock
or early failure in a young camera.
If it is still under warranty take it back to the seller for replacement.
Be aware - there is no repair option the makes economic sense.
SOURCE: Lens error
There must be to much dust in the lens track. You can take it apart and clean it out. Here are some internal pictures of the Nikon coolpix p2 lens.
Yes the possible solution is alright but there are errors within the camera. Sometimes the lens error is due to failure of the lens control system. You can remove battery and card replace battery and while switching on tap the lens hood on your hands so as to disengage any dirt or mechanism being struck.
Use some air to blow between the lens to dislodge any sand particles struck inside. If none of these works then you can think of taking consensus with the service center.
get estimate before you decide. It will be good to have it checked at the Nikon service as you do not have to run around for spares.
636 views
Usually answered in minutes!
×