SGCS304RS The two left burners work. The two right burners, spark but no gas comes out.

Hello Sharon,
are the two left hand burners "simmer burners" that low come on and go off to simmer a pot?
and the right side just set on and turn off without the simmer option?

if yes this pretty much describes your cooktop the part called the potentiometer is going the be the problem.

Hi,
Here is a tip that I wrote to give details about why your cooktop will not spark to light the burners..

Cooktop Range Stove spark ignition does not work

heatman101

Hi, This could be caused by something spilled on the burner, look at the electrode where the spark comes from and clean it up and make sure the metal right above it is clean as well. You should see spark at each burner regardless of which one your turning on. Assuming everything is clean, if you don't see spark on 2 of the burners, it could be 2 broken wires or a defective spark module (not likely if right side lights). Good luck

The igniters for the burners are all on one circuit so when you turn the burner to light the switch inside the burner valve will cause all burner igniters to come on. As far as the left burner not sparking it could be due to a bad igniter switch in the valve and when you turn on the right burner you are causing all(including the left one) to spark. You will need to make sure that the burner eyes are clear and not plugged. You can use a sewing needle to clear out the eyes. The small eyes at the igniter electrodes are very important because if they are clogged the burner will not light.

all burner igniters work at the same time - you may have a faulty electronic spark unit. change the spark unit. go to repair clinic dot come for the unit. also would be wise to check the ingniter start switch on the gas burner control knob

It works now.After two days of trying, it now works like it should. I'm thinking something needed to dry.

Hi JHMcdona

Most likely the electrode for the right burner is defective. As well as the switch may also be defective (is shorted because of pressing hard on it trying to make it work!!). Change the electrode and igniter switch of the right front burner.

Regards

There are a series of holes in the burner leading down from the main flame area to the pilot tube, ensure the holes are not plugged/restricted.

is this a sealed burner unit? if so the burner base (the heavy brass part under the burner cap) has to be sitting just right. you will notice that it has holes around the the sides make sure that where your ignitor sparks to it that it aligns with the lowest hole on the burner base. if you have a great flame all around the burner after checking what i mentioned i would replace the spark module. if it continues to drive you crazy with the noise - just unplug it. the burners will continue working fine without power.

Sounds like the electric sending unit for the right burners is not working. Do you hear the cliking noise on the right side when you turn the knob to LITE? If not then you need to replace the electric sending unit, they are located under the knobs, they are a smal square box that goes on the switch valve rod, they have tow wires on the side, just unplug and lift, and look for greasse or anything that might interrup contact, you might be able to use the same ones, or just replace with new ones....Good Luck
Eddie Rentas
Tupper LAke NY