I have a small Sanyo television hooked up to a dvd player for my daughter....problem is I can't get it to go to the AUX channel. Don't have the remote that went with it, but do have a Sanyo FXMG remote. Can you please tell me step by step on how to program them. Just need to get to the aux channel

Channel 4 will be the best.

where did you hooked up the connector wire coming from the dvd player, in the component input or at the RF jack of the tuner of the tv?. if you plug at the component input of the tv you will select AV1 or AV2 etc. in the settings. but if you hooked up into the RF jack you can select channel 3 in the tv but at this time you need to have manual tuned in the tv to get the signal coming from the dvd player or xbox.

It will depend upon which socket you plugged the DVD in to.
Usually AV1 or 2 and maybe Aux?

You can hook the Wii up with the standard RCA jacks and the DVD with the HDMI or vise verses. How many hook ups are on this TV. You can also run the Wii through the DVD using a aux channel on the DVD.

I have a sanyo dp-19649 tv and it's hooked up to a panasonic sound bar model# sc-htb10,and it's hooked up to a sony blueray dvd player. the sony player works on the sound bar but the tv doesn't.

I also have this ******* problem and apparently there is not solution. So just remember, next time you wanna find the urge to buy a ******* sanyo...dont do it. Sanyo = Bigfoots ****!

not really sure about this but if you put a disk in then run auto scan for your channels,long shot but worth a try.

your unit is equipt with audio video input jacks. It is located in front of the tv, right lower side. this is a video in and audio input for your dvd player.

do you have an input, tv/video, source or a/v button on your tv set if you do, press that, and it will change it

Yes, You need to be on AUX ,you can get to that setting by pressing channel 01 then press the channels down button instead of going to channel zero it will start to cycle through your AUX's inputs on the back of the tv.Also, another way to do this is on the original remote there will be a SOURCE button or INPUT button that can also cycle your TV through the aux inputs.REMEMBER.Make sure your DVD player is turned on and hooked up or else the AUX screen will be black.Rate me when you fix it!GOOD LUCK