I just had the same issue with 2 of my cameras, no night vision. Here's what I found after a little troubleshooting, in case this helps anyone. I used the diode check option on my volt meter to check each of the IR LEDs. Most measured around 1 volt but two were bad and didn't measure anything. I took two good LEDs from my other camera and replaced the bad ones. Fixed! I plan on buying a few more IR LEDs to fix the second camera. You can view the LEDs through your digital camera or cell camera to see if they are working. Hope this helps.
Where can you purchase the IR LEDs? How do you remove them to replace them?
I picked some up at Radio Shack. You'll need a soldering iron and solder to remove and replace them.
how do you take it apart to get to the bulbs? i took the front off but the bulbs are enclosed in a white plastic piece? thanks
×
Regards,
Tony
5,749 views
Usually answered in minutes!
×