I have an Electrolux Guardian Canister vacuum. The power cord was damaged but the cord winder still works fine. I have ordered a replacement cord and need to know how to remove the old cord and install a new one. I ordered the cord only, not the cord with winder reel.

There is a reset button on the power nozzle...not sure I heard of the vacuum canister has a reset button....hum.

Lift the front of the vacuum so the canister is at about a 75 degree angle. Gently tug and release cord. It may take a few tries, but it usually works.

Hi there,

This will not be difficult to open, however, inside may scare you.

Remove your hepa filter cartridge (if you have one)
turn the machine over.
Undo the 6-8 screws there and pull the bottom off.
you should see everything there. If you are careful, just remove the old rewinder, and replace with the new one.

Good luck.
Mark

The only way is to replace the cord winder assembly.

you have to replace the cord winder. Since eureka bought out electrolux their product quality has really went down the drain.

Take the hose unpluged see vaccum is working or not.
IF NOT.

1. BAG FULL
2. HOSE CLOGGED
3. BELT BROKEN/LOOSEN

Take out the bag and keep the door open.
While the bag door is still open, turn the machine upside down so you are looking at the serial number.
Pull the cord out one foot.
Use a puddy knife and put it between the rubber side rails and the **** end of the machine.
Use a hammer or malett to hit the putty knife from the back of the rubber bumber toward the bag door.
Pull the rubber bumber stright out on both sides.
Once both bumpers are out pull the lower body of the canister from the **** end toward the intake of the machine.
Once the bottom is open you can then service the motor, cord winder, switch, and all other components.
For all the parts to fix the machine visit: http://evacuumstore.com/c-69-electrolux-accessories.aspx?manufacturerfilterid=0

How to access and replace cord winder on Electrolux Guardian vacuum cleaner

Your cordwinder is broken take it to your local Aerus Electrolux dealer. If you have any additional problems call Liz at 570-326-1731

Call your local Electrolux office. Trying to fix it yourself will void your warranty. If you need any assistance call 570-326-1731 and ask for Liz, I will be happy to assist you if I can.