I replaced lamp on mitisubishi WD-60735. The Lamp light is still blinking yellow, the timer light lit up green, but lamp still blinking yellow

Hello, make sure that all the covers are on properly, was the old lamp broken? If it wasn't it may have not been the problem, sometimes the ballast board will cause the lamp light to blink like the lamp is bad....tks

Not going to fix that if the set even has that (which I doubt). Was the lamp a Mitsubishi or a generic cheap replacement?

when set goes off look to see if lamp is off or on, If you have to turn set back on or when its off, do the sets self check--press and hold both the menu and device buttons at same time for 5 second and release both---power light should blink a digit error code like 1,2, blinks pause and repeat that (1,2 is no error found and 3,7 is lamp issue.

you need to reset the lamp timer.

I have a wd-57731 The lamp light blinked orange. i replaced the lamp turned the tv on and the timer blinks green for one minute and then the lamp light blinks orange again. It won't turn on. Can you suggest anything?

you have a digitdl light processing (dlp) television, which uses a high-pressure mercury-vapor lamp. depending on the hours of usage,the lamp will last about 1-2 years. the red lamp most likely indicates the end of lamp life. the lamp will need to be replaced. the owners manual will have instructions on how to replace the lamp. you can order a lamp on line. i perfer a brand name lamp. follow the instruction carefullt. i found that the television needs to be unpluged for an extended amuont of time to completely reset the timers, at least an hour. i have an older model wd62525.

Hi:
This is an indiccation that your lamp has failed, replace the lamp and you will be good to go, If you heard a pop this was the lamp shattering in its enclosure. Just replace you lamp.

replace Lamp Call Mats Electronics 1-800-628-1118

replace the color wheel p/n 938P137010 MODULE-COLOR-WHEEL

There is a tiny reset button to the left of the timer light. Press with a pin or something small, wait 60 seconds. Viola!

I looked up the manual online - after you replace the bulb, you need to reset the bulb life timer. Using the TV remote push the menu button, SETUP menu, select the lamp reminder option to reset the hours to zero. That might help the status indicators.