What other units use the LC41 cartrage - Office Equipment & Supplies

6A80 - APP position error. Often there is something in purge unit

From the user guide:
Cartridge Error (1102, 1203, 1204, or 120F)
1 Remove the print cartridges, and close the cartridge carrier lids.
2 Close the scanner unit.
3 Disconnect the power cord from the electrical outlet.
4 Reconnect the power cord to the electrical outlet.
5 If the button is not lit, press .
6 Reinsert the print cartridges and close the cartridge carrier lids.
7 Close the scanner unit.
If the error does not reappear, the problem has been corrected.
If the problem reappears, one of the cartridges is not working properly. Continue with the following procedure to
determine which cartridge is not working properly.
1 Remove the print cartridges, and close the cartridge carrier lids.
2 Close the scanner unit.
3 Disconnect the power cord from the electrical outlet.
4 Reconnect the power cord to the electrical outlet.
5 If the button is not lit, press .
6 Reinsert the black (or photo) print cartridge and close the cartridge carrier lid.
7 Close the scanner unit.
8 If the error:
• Reappears, replace the black (or photo) print cartridge with a new one, close the cartridge carrier lid, and close
the scanner unit.
• Does not reappear, reinsert the color print cartridge, close the cartridge carrier lid, and close the scanner unit.
9 If the error reappears, replace the color print cartridge with a new one, close the cartridge carrier lid, and close
the scanner unit

Yes you should be able to just change the black ink cartrage, A lot of printer wont allow other third party cartrages, is it a genuine epson ink cartridge? if so try cleaning the contacts on the cartrage.

Restart the computer. Turn off the printer. Turn the printer back on after the computer is fully started.

Fiend your solution direct from EPSON. Here is your solution...

http://www.epson.com/printer/prob676ijt65/solution

tiuy24

Needs new print head, might be cheaper to buy a new machine

printer ane error prin color'nya g bisa

push and hold the reset button for several minutes until it works again

They do not all leak. The problem may be that your faucet is simply wearing out and is due to be replaced in total. Try putting some plumbers grease on the cartridge and the chamber.....not too much..........that may do the trick for u.

First off if you recently replaced the ink cartrages make sure you took off the blue or clear plastic strips on the cartrage. if you did then clean the copper looking contacts with a lttle alcahol when the units unplugged. Then let dry reinstall cartriages and try again >If that dosent help Im afraid the printer is not worth what it would take to repair.Good luck (unless its under a warrantee)