Control panel is stuck on 5Ab - Ovens

The error code shown on the display is"Sab", not "5ab".

To disable the Sabbath mode push and hold the Clock pad for 3 seconds.

hello

I think the control is set for sabbath mode operation. hold in clock button for 3 seconds to see if it will exit that mode. if this does not work, I will need the model number for your range. thank you.

Hi.


The beeping sound is a warning because the oven is in lock condition. The oven is not faulty, and the code is not 5AB, but SAB.

SAB means that the oven is in Sabbath mode, and the control board will be locked for 72 hours with SAB on display.

If power is disconnected a new 72 hours cycle will start.

Push and hold the Clock button for about 10 seconds, that will reset SAB mode.

If that does not work leave the oven connected and off for 72 hours. If the oven does not unlock after three days, then the electronic control may be stuck in SAB mode because it is faulty, in that case contact the manufacturer at the number listed on the owners manual.

Regards.

Hi.

I am publishing this tip because of the many users asking me about the code 5AB on Amana, Maytag and other ovens.

Error 5AB in fact does not exist , and what you see written on display isnot 5AB.

The beeping sound is a warning because the oven is in lock condition. The oven is not faulty, and the code is not 5AB, but SAB.

SAB means that the oven is in Sabbath mode, and the control board will be locked for 72 hours with SAB on display.

If power is disconnected a new 72 hours cycle will start.

Depending on the model, there may also be a beeping sound when you try to operate the oven.

Push and hold the Clock button for about 10 seconds, until the display clears, that will reset SAB mode.

If that does not work leave the oven connected and off for 72 hours. If the oven does not unlock after three days, then the electronic control may be stuck in SAB mode because it is faulty, in that case contact the manufacturer at the number listed on the owners manual.

Regards.

Hi. your assessment is correct. when you have normal operations with the stove top and the control panel is blank or non operational, this will confirm either a wiring harness issue or a dead control circuit board. The wiring harness can sometimes become lose or the connectors can become corroded but, in this issue, i am sure its the ECB(electroninc control board). In this case, you will have to replace the board it self.

Please rate and god bless:)

You unit is stuck in the "Display Model Mode". Hold the stop/clear button for at lest five seconds in insure the interlock activates. If it does not activate then the electronic range control (erc) is not functioning. Replace the erc (Clock/Display.)

According to the manual, this mode is SAB and not 5AB. SAB stands for sabath mode and lasts for 72 hours. The mode may be canceled by holding in the clock button for 3 seconds. This mode was activated by holding in the clock button for 3 seconds. My wife did the same thing when resetting the clock for daylight savings time this year. Resetting the power does not reset SAB mode.