Gas comes on for 5 seconds then goes out for 1 minute and then repeats over and over

What warning is it!!!

It sounds like a plugged or restricted exhaust vent or blower wheel might not b spinning, check blower and belt:)

1) Out door fan not working properly
2) Gas Leak (30 second working low pressure switch off)

Hard to find, but does this information help you :-

Setting the clock
1. press the clock button
2. press the cancel button
3. press the 1 and 10 minutes buttons repeatedly to set the hour, for example to set to 11 press the 10 minutes button once and the 1 minute button once.
4. press 1 and 10 seconds buttons repeatedly to set the minutes. For example to set to 29 press the 10 second button twice then the 1 second button 9 times.
5. press the clock button again

There's a heat sensor that's in the path of the flame. It's supposed to detect when the flame is lit properly so you don't fill your house with unburned gas.

I'd bet that sensor has gone south, or maybe the wire going to it.

What brand/model is it? A diagram and parts listing might come in handy.

The problem is the dryer coils are failing. They tend to fail as they heat up. Here is a link that should help troubleshooting a gas dryer.

contact amana tell them how long you have had it may still be under warranty if not they should be sble to help you out

Replaced the igniter. The parts guy told me that the amperage changes with age and use; thus the igniter still glows, but it takes much longer to operate the gas valve with the reduced amperage. Cost - $70.14

tap on the power supply borad not to hard
and have some one let you know if pix fark out
go all thur all the board soune like you have bad solder jonts

Try cleaning the flame sensor. It is located right besides the last burner. Looks like a thick piece of wire. Take steel wool and gently remove the carbon that has built up. Should only take 4 or 5 strokes. Let me know how it goes after that. ken