How do I change the tax rate on my Casio dr-210hd from 5% to 6%?

Set the decimal slider to 2 places. Not F

Youll find your answer right here in the manual:

 

http://www.retrevo.com/support/Casio-DR-210TM-Calculators-manual/id/12440bh226/t/2/

 

800kb pdf file.

 

Hope this helps. Good luck!

 

kc

Observe the devices function keys to ascertain any menu or mulltifunction buttons. Multifunction keys perform several features. First the multi key integrates several features to minimise the extraneous requirements wit micro computer keypads. Second, multifucntion keys perform the additional fucntions least visible at initial observation. Calculors as simple computers onlyl produce transaction requests though allowing to adjust features to suit productivity. Perform an observe of the device to familiarise with the adjustment status condition. In the instance were the device were dessign least to allow an alteration of calcultion percentages makes alteration unachievable. Refer to the devices oner user guide to ascertain the capacities if functionalities among several resources made available from the manufacturer.

I found my manual papers.

Push the CA button
Hold down the set key (%) until the 0 prints and shows on the screen.
Then type in the new tax amount and hit Tax+ .
You will also need to repeat the above for the Tax- .
This works for my DR-220HD Casio Calculator.
Good Luck

To change tax rate on Casio DR-210TM:
Hit <CA>
Hold <%> for 5 sec until '0' re-appear
Enter 'Tax Rate' and <TAX+>

So just 5 easy steps to change the rate

1 press the AC button
2 hold down the SET /SET % / button for a few seconds
3 press the TAX + button
4 input the rate /in your case 6/
5 press SET button again
And you are done. You can also check it - press the Tax + button and the current tax rate will appear

Hope I helped !

1. Switch off the calculator
2. Switch it on again
3. Press and hold the tax button (set %) until the display changes
4. Enter the new tax rate
5. Press the tax button (tax +)

Any problems contact [email protected] - he emailed the solution to me and it has worked.

Pam

refer to dr-250hd calculator

make sure you are in "print mode" step 1 pess the AC button step 2 press and hold for two seconds the % button step 3 press the tax+ button step 4 input tax rate step 5 press the % button now check to make sure that is correct.

Printing models (except HR-8TE): 1. Have calculator in ?print? mode 2. Press [CA] 3. Hold [SET/%] key for about 3 seconds 4. Input the tax rate 5. Press [TAX+] 6. Press [SET/%]