HAMMER MODE SLIPS OUT

turn the selector lever from hammer / drill to hammer
it is a second lever close to the gear box of the drill

turn the selector handle to hammer or move the slide button across to hammer
remember that it will not hammer until you put pressure on the drill bit

Dewalt XRP drill gearbox - YouTube

? 3:16
https://www.youtube.com/watch?v=s262yXyUYD4
Nov 23, 2011 - Uploaded by Ultimate Handyman
This is extremely useful if the gearbox on your drill is damage... ... i was using my dewalt hammer drill in the drill mode and suddenly got slower i though the battery was running out. as i ...Looking forward to the repair video.

check clutch adjust,put it in drilling mode
check if speed selector is in right position
after that if it slip aggain,you need a gearbox

You can get the part replaced with metal gearing and clutch and that shouldn't happen again, but the cost may not be worth it

Make sure the bits that you put in there are SDS+ bits. You don't have an adapter in the drill do you?

Check the speed selector switch. if it is not fully engaged (usually because of dirt) the gears will slip. cycle the switch a few times.

if i'm confused i'm sorry, but don't confuse and impact driver with a hammer drill

2 different tools altogether

hi

try to figure out how the switch operation mode works and put back together right.

bye savumihai71

what is the setting in your clutch. if you set the clutch to the highest setting and it`s still slipping then you need transmission assy.