I have a bosch classixx dishwasher it fills with water but arms do not spin during cycle

The Bosch may have a similar setup to the Meile where the main wash motor has a diverter which controls the water flow to the upper , then the centre, then the lower arms in sequence. When this sticks, the little drive motor "clicks" as it is trying to turn the diverter but cant. It will eventually fail. You may have to pull the motor out to check.

Try cleaning the detergent draw somtimes this can cause water to spill out and ofcourse check the filter and exit pipe :)

Hope this helps
TalkAppliance.co.uk

I have same problem - did you manage to get yours fixed??? Any suggestions?

Where does the clicking sound seem to be coming from? Start the machine and when it's filled with water, try to identify where the clicking noise is emanating from. I suggest putting you ear next to the programme selector and start/stop switch and see if you can hear it more loudly/clearly.

Sounds like a faulty control module to me. Try the above and report back . . .

Hi,

I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms online and installed them in minutes...now the thing works like new... However I have also found that if the heating element goes bad then that also can mess things up bad... So I would buy new spray arms, and also check out the heating element to make sure it is working... Here is a tip that will help you with the online buying...

Dishwasher Spray Arms not Spinning

How to Buy Appliance Parts Online

A bad heating element causes many problems in dishwashers...

Dishwasher Problems The Heating Element not Working

Dishwasher Maintenance

heatman101


fhjlyrfu

build up of calcium clean your hoses check your lines they maybe blocked sound like a high pitch squeak something is stopping it from getting water

It all stems back to your incomming water supply. Either the sieve is dirt or the valve is blocked with sedementation. Some valves are servicable and some are not,if your valve has screws then its revicable. (low water pressure restricts movement on arms.)

the arms spin from water pressure,there is not enough water check fill valve.

Motor pump has gone out. pump needs replacing. the unit needs to be pulled out inorder to access the pump. the sides of the d/w must come off.

the spray arms are rotated by water coming out of angled jets, this water being forced round by the main circulating pump. suspect it may a fault with this pump