I get the error code FSE1, lock won't engage message for the bottom oven everytime I turn on the top or bottom unit. The message will not go away until I turn the top unit off. The bottom lock keeps trying to engage while the top oven is on and the light won't work while the message is on.

Question 1

0helpful

1answer

I have double Gooldseries ovens. We had extended power failure and when power was restored I attempted to preheat top and hen bottom ovens and get “feature not available”

Try a power reset:

Reset power to the product:
Power unit down by turning off the circuit breaker(s) or fuse(s) for one (1) minute.
Power unit up by turning on the circuit breaker(s) or fuse(s).
Monitor the oven for one (1) minute to ensure the error code does not display again.
Verify oven operation.

Is there an error code?

Dec 24, 2018 • Ovens Ovens

0helpful

1answer

Thermador Model CM302ZS self cleaning bottom oven will not engage and error code F84. It locks and stays locked even though there is no heat. After an hour or so it will unlock

f84 lower door latch shorted input. You may need to have the latch replaced.

Oct 24, 2016 • Ovens

0helpful

1answer

Bottom oven stopped working there is a key symbol showing on the panel what is wrong ?

There are a few reasons for this. One is the most obvious and that is the child lock switch needs to be engaged to unlock.Some models call it panel lock.
Turning the panel lock on and off:
To turn the panel lock on, press and hold the Panel Lock key for four seconds. The Panel Lock symbol will appear in the display.
To turn the panel lock off, press and hold the Panel Lock key for four seconds. The message in the display will disappear.

Oct 04, 2014 • Bosch HBL 5056 Electric Double Oven

0helpful

2answers

KITCHENAID OVEN MODEL KEMS 308 SELF CLEANING

Good Morning,
Sometimes an F5E1 will appear when the control board is faulty.. because it isn't properly driving the door latch circuit properly. If the door latch assembly is fully functional, we recommend sending in your oven control board to Fixyourboard.com for testing and/or repairs. Reach out to them at 512-355-1108 or [email protected] They also have replacement touchpads for this model oven if needed.
ledgestone microwave oven keypad-crjxtk2pui4xc5qqbhljddcq-2-0_0.jpg

ledgestone microwave oven keypad-crjxtk2pui4xc5qqbhljddcq-2-0_0.jpg

ledgestone kp2b1705-crjxtk2pui4xc5qqbhljddcq-2-2_0.jpg

Jan 01, 2012 • Ovens

1helpful

1answer

F5 error code

F5 = EOC electronic control failure replace electronic control is stated in the service manual. If you have any further questions message me them back. Thank you
Rick

Nov 28, 2011 • Thermador SC302T Electric Double Oven

1helpful

1answer

F5E1 or FSE1 error code DOOR LOCKED LATCH NOT OPERATING

On this double oven, each door has it's own latch mechanism that consists of a motor, a position switch, and the door switch used to activate the cavity lights. Because the error indicated a latch failure (and the bottom door was locked), Start by cycling the power to the unit. Each time the power is removed and then applied to these ovens, both latches will lock then unlock the doors to ensure they are in the home open position. By doing so, you might be able to get the bottom oven door opened allowing me access to the latch assembly. With the latch removed, I try to begin a clean cycle so you could watch the motor operate and you will probably find that it will start to turn, but never would rotate enough to lock the door. Since the position switch was not actuated at the end of the motor operation, the F5 E1 error was again displayed. Replace the motor assembly
E

Nov 23, 2011 • KitchenAid Architect Series KEMC308KSS...

0helpful

3answers

I have a Whirlpool Super Capacity 465 self-cleaning oven. I tried to use the Auto Clean function tonight, but after about 15 secs., the oven displayed error code FSE1, beeped multiple times, and then...

I researched your question regarding error code FSE1. I could not find a response regarding a self cleaning oven. If you will provide the model number on the below listed website under "cooking" you may get a detailed response.
http://producthelp.whirlpool.com

It seems that a general "fix" for error codes is to got to your electrical panel and shut off the breaker controlling your device for 1 minute. This resets the device and will reset the error code. (May not fix your issue but will reset code.)

Your manual should have a list of error codes to help you resolve this issue. If you have misplaced the manual, you can also download one for your device from Whirlpool's website as well.

If all else fails here are the U.S. and Canadian telephone numbers under "Contact us". I do not know if this is a pay line or Whirlpool will answer your questions and attempt to resolve at no cost.

US: 1-866-698-2538
Canada: 1-800-807-6777

Jan 02, 2018 • Ovens

2helpful

1answer

FSE1 button won't stop beeping every few minutes. I've unlugged the oven, plugged it back in, and it starts going off again. How do I get it to stop?

This may answer your question:

http://appliantology.org/topic/29234-whirlpool-kitchenaid-built-in-double-oven-f5-e1-error-code/

Feb 05, 2011 • Whirlpool RBS305PDS Electric Single Oven

0helpful

1answer

Whirpool range type p30 when trying to enter the clean oven mode it flashes error FSE1

HI. the keypad is experiencing issues at this time. follow the steps below to address this problem.

1. Check keypad connector for firm connection (keypad connects to control board).

2. Press CANCEL. If error code returns after 60 seconds, replace keypad (also called touch pad or membrane switch). Some models incorporate keypad in to control board as one unit. In this case, replace control board (also called ERC or clock).

Nov 02, 2009 • Ovens

2helpful

1answer

Code fse1 comes up when a few minutes after pushing start to cle

F5 - E1 Self clean latch will not lock

1. If door latched:

Disconnect power from unit.
Check wires and connectors from control to door switch, then from door switch to control. If no damage to wires and all connectors okay, proceed to step C.
Replace door switch.
Re-apply power.
Press and hold any key down for 1 minute to clear F5 failure code from memory. F2 will appear. Press CANCEL and observe for 1 minute to ensure operation is correct.

2. If door not latched:

Disconnect power from unit.
Check wires and connectors from control to latch switch, then from latch switch to control. If no damage to wires and all connectors okay, proceed to step C.
Repeat steps A and B for door switch.

3. Measure door switch (door open = switch open small low voltage terminals). Replace switch if defective.
4. Measure latch switch (unlatch = switch open, CAUTION - oven light contacts are closed). Replace switch if defective.
5. If corrections are made in any step, reconnect power to control. Press and hold any key for 1 minute to clear R failure code from memory. F2 will appear. Press CANCEL and observe for 1 minute to ensure operation is correct.
6. If failure remains, disconnect power and replace control.

Apr 01, 2009 • Ovens

Question 2

espressonist

KitchenAid Master 1,711 Answers
Posted on May 05, 2011

espressonist

KitchenAid Master

Joined: Feb 13, 2010

Answers

1711

Questions

1

Helped

652110

Points

5029

F5 - E1 Self clean latch will not lock

1. If door latched:

Disconnect power from unit.
Check wires and connectors from control to door switch, then from door switch to control. If no damage to wires and all connectors okay, proceed to step C.
Replace door switch.
Re-apply power.
Press and hold any key down for 1 minute to clear F5 failure code from memory. F2 will appear. Press CANCEL and observe for 1 minute to ensure operation is correct.

2. If door not latched:

Disconnect power from unit.
Check wires and connectors from control to latch switch, then from latch switch to control. If no damage to wires and all connectors okay, proceed to step C.
Repeat steps A and B for door switch.

3. Measure door switch (door open = switch open small low voltage terminals). Replace switch if defective.
4. Measure latch switch (unlatch = switch open, CAUTION - oven light contacts are closed). Replace switch if defective.
5. If corrections are made in any step, reconnect power to control. Press and hold any key for 1 minute to clear R failure code from memory. F2 will appear. Press CANCEL and observe for 1 minute to ensure operation is correct.
6. If failure remains, disconnect power and replace control.

Note: Applies to all F5-E... codes.

Answer 2

Megan Webb

Expert 63 Answers
Posted on Jun 19, 2019

Megan Webb

Expert

Joined: May 31, 2015

Answers

63

Questions

0

Helped

50045

Points

296

Good Morning, Sometimes an F5E1 will appear when the control board is faulty.. because it isn't properly driving the door latch circuit properly. If the door latch assembly is fully functional, we recommend sending in your oven control board to Fixyourboard.com for testing and/or repairs. Reach out to them at 512-355-1108 or [email protected] They also have replacement touchapads for this model oven if needed.
I get the error code FSE1, lock won't engage - ledgestone microwave oven keypad-crjxtk2pui4xc5qqbhljddcq-2-0.jpg

Limited supply of refrigerator boards for sale Used...

fixyourboard.com

Related Topics:

Trustworthy Expert Solutions

I get the error code FSE1, lock won't engage message for the bottom oven everytime I turn on the top or bottom unit. The message will not go away until I turn the top unit off. The bottom lock keeps trying to engage while the top oven is on and the light won't work while the message is on.

2 Answers

espressonist

Megan Webb

Add Your Answer

Attachments: Added items

Related Questions:

I have double Gooldseries ovens. We had extended power failure and when power was restored I attempted to preheat top and hen bottom ovens and get “feature not available”

Thermador Model CM302ZS self cleaning bottom oven will not engage and error code F84. It locks and stays locked even though there is no heat. After an hour or so it will unlock

Bottom oven stopped working there is a key symbol showing on the panel what is wrong ?

KITCHENAID OVEN MODEL KEMS 308 SELF CLEANING

F5 error code

F5E1 or FSE1 error code DOOR LOCKED LATCH NOT OPERATING

I have a Whirlpool Super Capacity 465 self-cleaning oven. I tried to use the Auto Clean function tonight, but after about 15 secs., the oven displayed error code FSE1, beeped multiple times, and then...

FSE1 button won't stop beeping every few minutes. I've unlugged the oven, plugged it back in, and it starts going off again. How do I get it to stop?

Whirpool range type p30 when trying to enter the clean oven mode it flashes error FSE1

Code fse1 comes up when a few minutes after pushing start to cle

Not finding what you are looking for?

Architect KEBS208S Electric Double Oven

I have double Gooldseries ovens. We had extended power failure and when power was restored I attempted to preheat top and hen bottom ovens and get “feature not available”

Ask a Question

Top KitchenAid Ovens Experts

ZJ Limited

Cindy Wells

vince

Are you a KitchenAid Oven Expert? Answer questions, earn points and help others

Manuals & User Guides

Related Topics:

Trustworthy Expert Solutions

I get the error code FSE1, lock won't engage message for the bottom oven everytime I turn on the top or bottom unit. The message will not go away until I turn the top unit off. The bottom lock keeps trying to engage while the top oven is on and the light won't work while the message is on.

2 Answers

espressonist

Megan Webb

Add Your Answer

Attachments: Added items

Related Questions:

I have double Gooldseries ovens. We had extended power failure and when power was restored I attempted to preheat top and hen bottom ovens and get “feature not available”

Thermador Model CM302ZS self cleaning bottom oven will not engage and error code F84. It locks and stays locked even though there is no heat. After an hour or so it will unlock

Bottom oven stopped working there is a key symbol showing on the panel what is wrong ?

KITCHENAID OVEN MODEL KEMS 308 SELF CLEANING

F5 error code

F5E1 or FSE1 error code DOOR LOCKED LATCH NOT OPERATING

I have a Whirlpool Super Capacity 465 self-cleaning oven. I tried to use the Auto Clean function tonight, but after about 15 secs., the oven displayed error code FSE1, beeped multiple times, and then...

FSE1 button won't stop beeping every few minutes. I've unlugged the oven, plugged it back in, and it starts going off again. How do I get it to stop?

Whirpool range type p30 when trying to enter the clean oven mode it flashes error FSE1

Code fse1 comes up when a few minutes after pushing start to cle

Not finding what you are looking for?

Architect KEBS208S Electric Double Oven

I have double Gooldseries ovens. We had extended power failure and when power was restored I attempted to preheat top and hen bottom ovens and get “feature not available”

Related Topics

Ask a Question

Popular Questions

F6E0

Superba convection oven probe display problem

OVEN will not heat

Cleaning Inside Glass Oven Door of KitchenAid KEMC308KSSO

Kitchenaid Microwave torsion spring replacement

Top KitchenAid Ovens Experts

ZJ Limited

Cindy Wells

vince

Are you a KitchenAid Oven Expert? Answer questions, earn points and help others

Manuals & User Guides