Need a smbus controller for an emachines t6524..anyone? thanks so much

Please check following KB article:

Advanced troubleshooting for shutdown problems in Windows XP
http://support.microsoft.com/kb/308029

please go to this url so that you can download. :) --> http://members.driverguide.com/driver/detail.php?driverid=1265100

Have you tried System Restore? Restart your computer and watch for the screen to give you instructions at the bottom. It will say something like: F1 = Boot Menu F10=System Restore
It should walk you through a factory restore, which means it will take it back to factory settings the same as when it was perchased.

Hardware fault. Simple test: if you can boot in the BIOS then the hard disk has died - replace it and reinstall. If you can't the the motherboard has failed - in the end it will be easier and cheaper just to get a new pc.

Go to start menu
Click on all programs
click on Emachine folder
click on Emachine Recovery Management
Click on restore on the bar across the top
click on restore to system factory default
Complete restoration takes about 20 minutes to complete

hello...the exact problem on the CPU/unit is Memory so you need to try clean the memory or try to replace a new memory...Thanks and Good Luck...

Try this link it's the company's website. Download all drivers and install. I hope this helps.
http://www.emachines.com/support/product_support.html?cat=Desktops&subcat=T Series&model=T6524

Hey,

seems like your missing the sound card drivers.
available for download here
http://www.emachines.com/support/product_support.html?cat=Desktops&subcat=T-Series&model=T6524

Let me know if you need anything else.


Thanks,
Ekse

this is a internal problem with the display. you need repair

Hi Robert,

Have you checked to see that there is no cabling of any sort in your machine that may be brushing with the side panel when it is closed? I'm thinking maybe a GRND pin from either the front panel connectors or a USB connector but this is only a guess. I am unsure why a panel could stop it turning on! Let me know if its resolved! :o)