I HAVE TROUBLE GETTING MY TREADMILL TO GO. WHEN YOU TURN IT ON IT IS VERY SLOW DOESN'T MATTER WHAT SPEED YOU HAVE IT ON IT NEVER GETS TO THE SPEED AND THEN WHEN YOU STEP ON THE TREAD MILL IT STOPS. WHAT CAN I DO

Is the belt correctly tensioned. Do you feel that the belt is slipping. Does the motor noise change and slow down, or does the motor sound the same? If it slows, then the motor is failing, or you have exceeded it's weight capacity. If the motor remains at the same speed, then the belt is slipping with you as the resistance on it.

https://www.youtube.com/watch?v=GAolnpKK3yM
The most likely cause for the motor to speed up and slow down is a dry or worn walking belt or walking board. Lift the walking belt and feel underneath for worn spots on the board. ... This mode also allows the technician to calibrate the speed and incline of the treadmill whenever a major electrical component is replaced.

Please exchange the Control board motor, the Components IGBT, are faulty. Replace .
Blessing.
[email protected]
cell+whatsAPP:+50588611441

DEAR
IF IT STOP AFTER 6 OR 8 SECOND YOUR SPEED SENSOR IS NOT FIX AND ITS OUT OF SERVICE YOU MUST FIX IT SIMPLY AND YOUR TREADMILL WORK AS WELL
you can countiue contact us with smart phone on wattsapp or telegram by :
+989195116738

Hi, It's probably the speed censor. Clean it up and should be good to go. When you disasemble it clean all other parts and put back togeather. Good luck

worn belt and deck

this is a trouble shooting guide for speed issues with a treadmill. Hope this helps.


http://www.treadmilldoctor.com/Testing-for-Speed-Problems?utm_source=fixya&utm_medium=CPC&utm_campaign=Mendi

Dear Sir:

You have trouble with your sensor speed need to adjustment.

Run the calibration software for easy diagnose and troubleshooting

Otherwise see my personal TIPS, for diagnose
Trouble.

sincerely, God bless you.

ernesto a cuadra
managua, nicaragua c.a

if you look at the front roller. there will be a black device that has two wires. this is your speed sensor. Make sure it is facing the magnet on the roller.

run the drill slow while changing the speed of the drill