I need a free diagram of the belt assembly for a Kubota TG1860G mower I have no manual and need to replace the belts.

http://www.ssbtractor.com/wwwboard/view.cgi?bd=kubota&msg=37010

You just go to the link I attached I'm sure you will get the solution of your problem -

https://www.reliable-store.com/products/kubota-t2080-lawn-mower-serial-number-10660-workshop-service-repair-manual

I found this for you...... Hopefully this might help....... http://www.kubota.cz/data/manualy/gr-2100-wsm-en.pdf

Two ways to do this. Try Google as I found the answer to your question in less than 5 minutes of research. Or go to a Kubota dealer and ask him for the drive belts. They will have a manual for your mower with the information on the belts. The last time I replace the belts on my mower, the dealer had the information in seconds and the price was competitive with an internet search.

http://www.kubota.com/part/parts.aspx


if you start here, you maybe able to find the manual

Kubota Tractor Manual Kubota Manual

Removing the center pulley assembly from a Kubota deck RCK54-24G will require some specific steps, and tools, as well as some knowledge of mechanical systems. Here are some steps you can follow:

1. Park the machine on a level surface and engage the parking brake.
2. Remove the belt cover by removing the fasteners or clips that hold it in place.
3. Remove the belt by releasing the tension on the idler pulley and slipping it off the pulleys.
4. Use a socket or wrench to remove the center pulley nut and washer.
5. Use a puller or gear puller to remove the center pulley from the shaft.
6. Clean the pulley assembly, shaft, and deck.
7. If the pulley is damaged, it should be replaced.
8. Reinstall the pulley assembly in the reverse order of removal.
9. Tighten the center pulley nut to the specified torque.
10. Check the belt alignment and adjust it if necessary.

It's important to follow the manufacturer's instructions and use the right tools and equipment when working on the machine. If you are not familiar with the mechanical systems, it's best to take the machine to a qualified Kubota repair service center, they will be able to diagnose and fix the issue.

Typical Kubota mower spindles are mounted with 4 bolts. Some have 4 more on a larger support plate. First the belt pulley must be removed, possibly with the help of a jaw-type puller. Then remove the 4 bolts around the perimeter of the spindle. Using a soft mallet or wood block, drive the spindle assembly down through the deck, making sure there is room underneath for it to fall. Kubota sells replacements as complete assemblies which saves a lot of time vs. rebuilding the spindle.

Try going to kubota.co.uk and see if a diagram is available there.