Where can i get a replacement drain cover..ive lost mine moving

well you didn't say what type mower u got , belly or three point , but the drain holes for water are most times right next to the blade drive spools there only about 1/4 inch in size so they do get clogged up easy , but its important to keep them clear or you will ruin your bearings in your blade drive posts (rust) me I have modified mine (blade drive posts) to include a tapped hole to screw a grease fitting into and i fill void with grease instead of oil (lasts way longer in the field ) especially since mine never come back to the barn (unless there broken) as I just drop mine at the edge of the hay field and drive the tractor home

but if your speaking of the oil drain holes for the right angle drive , its on the bottom , but ive found that they didn't allways poke a hole for it thru the sheet metal to access it without removing the rightangle drive ( never get under a machine using only the three point as a jacking device, that's how I lost my brother in law ) use a ole tree as a safety leg to hold it up instead

We lost ours in a move too! It plugs in near the bottom/front on the R side of wheel cover. What are the specifications of thr replacement? How many volts output, etc? Thanks

call or email these sites and ask them about the bobbin cover
sewvacdoctor.com
a1sewingmachines.com

If it's an older Navigator and it just recently started to hang up on the drain cover, replace the throat assembly, part 29. The lugs or hold offs on the bottom of the assembly have worn down and are not breaking the suction as the Navigator travels over the top of the domed drain cover. Replaced mine and no longer have the "my navigator gets stuck on the main drain" problem.

Mine is the same way, Ive been told that in order to fix it, you have to replace the entire fuel pump and sending unit. Ive been told it could run $700!

Remove the front cover at the bottom of the washer. Your drain hose and/or drain may be filled with sediment. I just cleaned mine and it fixed my no spin problem......also directions for doing so are in your manual. I used a large dog bowl to catch the water. If no water comes out of the drain hose after you unscrew the cap, squeeze it and see if gook comes out. Then remove the other cap (use a coin) and pull it out. Mine had years of dog hair, sand, coins in it. After I cleaned them, replaced them, spinning returned.

Not in vain...the part number for the cover is
LP1154005, it sells for around $5.00 try google to find one or www.brothermall.com

i have lost my web cd and now i want to install again so what i do?

The solution, by jimr929, to not touch the lens cover at all, works perfectly for me too, as mine is also a 2002 model.

rjbjboll----How did you remove the lens cover?


stillthere

The pump is at the lower left of the front of the machine covered by a white plate. Use a bowl to catch any remaining water when opening the screw thread inside and then clean and replace. If it is truely beyond repair then a new filter pump can be bought from ebay for £3 or thereabouts.

I have just drained mine manually in this way and am going to run it empty with soda crystals to glean a few more days use whilst the new pump arrives.

Good luck :)