Basket handle release broken. Cannot locate part

The FH50150 model is a Hoover Power Scrub Deluxe Carpet Cleaner, which features a handle release button that is used to adjust the handle's height and fold the machine for storage. If the handle release button is broken or damaged, it may need to be replaced.
Here are the steps to replace the handle release on a FH50150 model:

1. Unplug the machine from the power source and remove the solution tank and recovery tank.
2. Lay the machine on its back, so that the underside is facing upwards.
3. Locate the handle release assembly at the base of the machine's handle. It will have a rectangular shape and a small metal spring inside it.
4. Using a pair of pliers, gently remove the metal spring from the handle release assembly and set it aside.
5. Next, remove the handle release button by pressing on the two tabs that secure it to the assembly. You may need to use a flathead screwdriver to push the tabs inward.
6. Once the button is removed, slide the old handle release assembly out of the handle.
7. Take the new handle release assembly and slide it into the handle, making sure that it is securely in place.
8. Attach the new handle release button to the assembly by pushing it in until it clicks into place.
9. Finally, insert the metal spring back into the assembly, making sure it is positioned correctly.
10. Test the handle release to ensure it is working properly.
11. Once you are satisfied that the handle release is working correctly, replace the solution tank and recovery tank, plug in the machine, and you're ready to use it again.

If you are unsure about any of these steps, it is recommended to consult the user manual or contact the manufacturer for assistance.

Definitely. Just find your local authorized BEAM dealer and they will sort it for you. Sorry, I don't know where you are so I can't find you a dealer but BEAM's website has a dealer locator.

Hello augustus_ eli - To remove the top and/or bottom basket, pull the basket(s) out until it stops. Then, lift up on the handle and pull out at the same time to completely remove the basket. To reinstall top and/or bottom basket, align the basket with the rails and push in. The middle basket is held in place by four retainer clips; two on each rail. Before removing the basket, note the location of each retainer clip. To remove the baskets from the retainer clips grasps the handle firmly and pull up. The basket should release from the retainer clips. To reinstalled the basket place the basket on top of the retainer clips and press down.

I have an old Phoenix AEG juicer - don't know if it's the same as yours. My basket is two-part. The flat bottom part with the grinder teeth holds in the strainer part, and has small holes at twelve o'clock and six o'clock. There is a clear plastic "wrench" which consists of a circular plate with a perpendicular ridge on top serving as a handle, and two pins on the bottom that fit in the two holes. You then unscrew the flat bottom part of the basket which releases the remaining strainer basket part. If you're missing the wrench you might be able to improvise.

sounds like a problem with your basket drive assembly brake release arm could be broken not releasing the brake allowing the basket to spin,,,,,

REMOVED PANEL FROM UNDER THE BUMPER AND REACHED UP TO THE TOP OF BONNET AND LOCATED CABLE. PULLED ON CABLE WHILST 3RD PARTY PULLED BONNET LEVER IN DRIVERS FOOTWELL. BONNET RELEASED.

I boughta new handles

You also have to pull on the middle part by the basket it has like a handle.

what is part number for broken pedal release