Hotpoint wmd 960 ultima,when press start button nothing happens apart from the clock starts count down to end of wash

thier r 2 bearrings and a seal its called a bearring kit not very easy if u havent done it b4.

Ring DS suplies 01782-625551 ask for chell

Good afternoon
Your washing machine has more difficult problems than I have met before.
The only thing I can advice you is to get an electrical expert from
a shop that specializes in your type of machine.
Whille you are waiting you could browse on the internet and look at MANUALSONLINE.COM
kolbrun

F7 generally mean heater relay is stuckcheck the linkhttp://www.hotpointservice.co.uk/hs/pages/content.do?keys=FAQ:ERROR_CODES

Look within the drum and observe if there is any dirt on it. Also check the quality of water. Check if there is any dirt /grease from the drum bearings due to failure of the bearings/seals.
Finally have the machine cleaned using good detergent cleaner , please check the link below for some tips:

http://www.espares.co.uk/parts/cleaning-products/dishwasher-cleaning/p/1423

Try the following, may work:

1. Press the Start/Cancel button together until all the console Led's illuminate
2. Press both Start/Cancel and On/Off buttons together until 'd off' appears
3. Default screen should return and you can select a new programme

I think you have a failed control panel circuit.

Error code F04 means pressure switch jammed on empty.
Do the following.
Remove lower rear panel of washer.
Remove large black hose on bottom of drum.
Remove and clean filter inside the hose.
Remove the hose on to the pump, and check for blockage or obstruction here as well.
Please rate my solution.
Thankyou.

To get out of it you need to press start, the display should go daft. Press start again and the display should settle down. Now press the on/off button and the start button at the same time and hold them down for a few seconds until the display shows d-end or d-off.
Your machine should now work. hope this helps.

try this - press start, press start again. Now press the on/off button and the start button at the same time and hold them down for 5-10 seconds until the display shows d-end or d-off.