Will not coming on ,standby light is orange temp and lamp light not on

I recommend trying a new lamp, part# BP96-01472A

see the following website: http://www.shopjimmy.com/catalogsearch/result/?q=+BP96-01472A

(Ah, I didn't see this box before I logged in, and now I can't delete the "comment" that says the same. In any case, copy annnnnd... paste!)

If it's an orange or grey + orange coloured one, with no controls on the body other than the two service buttons, then it's been ripped off from a Smartboard interactive whiteboard system in a school, college, office, etc - either by a thief, or during a genuine but misguided stripdown whilst the system was being junked. It won't function without being connected to the rest of the system. The light sequence you see is normal for it being connected to the mains, giving an "all clear" indication, then settling back into standby. You MIGHT be able to make it work with a suitable remote, but it does sound mostly that you're running into an anti-theft lockout...

It's for the best, they're rather fragile and wear out somewhat quickly. Get hold of an NEC or HP or something instead, they're rather more hardwearing.

Green light is for power on red light follows when heater lights when set temp reached the unit shuts down to standby

check the lamp if you havent changed it before that would be the easiest place to start. if the lamp is popped you will see glass pieces rolling around in the lamp.

Sounds like a samsung but I will need the model number to assist you more accurately. Please respond to this same post.

Hi
This would be "Standby"
When you press standby, the display and audio turn off and a blank screen is displayed for 15 minutes.
You can change the amount of time the projector stays in standby mode; see “Standby Time” on page 27 for details.
The LED lights orange while the projector is in standby.
• If you press standby again within 15 minutes, the projector returns to normal operations immediately. The LED changes from orange to green.
• If you press standby again after 15 minutes, there is about a 60 second delay before the lamp turns back on. The LED flashes green while the lamp is re-lighting.
• If you don’t press standby again, the lamp turns off after 15 minutes. The LED lights orange while the projector is in standby.
The full manual can be found here:
Infocus customer support
Infocus LP350 Manual
I hope these help
Mike

the lamp ballast is bad and needs replacement.

The most common blink code for the Standby/Temp LED is the Temp Sensor and or Actuator Board. You can confirm which on by jumping the CN106 connector on the Actuator board. If the set works now, the Temp Sensor must be replaced. If it doesn't work, the Actuator Board would need to be replaced. If you are not familiar with the chassis or electronics at all , I do not recommend trying to fix it, call a professional. Don't take the chance of damaging it further.
I hope this helps,
Skyassoc

The problem is most likely a defective lamp. See your owners manual on lamp replacement as this can be done by the consumer.

This same thing happened to me, I removed the bulb and put it back in, it reset something and I was able to use the projector again.