I need to find my nearest onkyo repair centre for my now faulty 806 reciever as hdmi out is non existent, i am based in merseyside?

It's in the manual of nearly every piece of audio electronics to ensure adequate ventilation.

http://www.retrevo.com/support/Onkyo-TX-SR606-Receivers-manual/id/16690ag612/t/2/

"7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions."

"18. If you install the apparatus in a built-in installation, such as a bookcase or rack, ensure that there is adequate

ventilation. Leave 20 cm (8") of free space at the top and sides and 10 cm (4") at the rear. The rear edge of the shelf

or board above the apparatus shall be set 10 cm (4") away from the rear panel or wall, creating a flue-like gap for warm air to escape."

But who actually reads the manual?

Have you proven that a straight shot HDMI to the TV from either source solves the problem?

For all we know the TV or it's HDMI cable could be faulty.

The chances are that you have selected an incorrect sound setting or not switched it on, for the HDMI you are using. With Onkyo receivers each connection will have it own settings for video and sound. You just need to look in the manual as to how to select the settings.

I assume that the HDMI works fine if you go directly from the dish receiver to the TV with either HDMI cable. And try it with a different source (DVD or x-box) in the same input port.

Take it to a Radio Shack there service centers can repair Onkyo in warranty. Most Onkyo receivers carry a two year warranty.

Are you not getting audio to the television speakers and the onkyo reciever speakers when connected HDMI thru the reciever or just the television. If it is just thru the television then it is because the reciever is grabbing the HDMI audio signal and converting it so it does not reach the TV. If it is both then try changing the HDMI signal output from PCM to DOLBY DIGITAL on the computer. Your reciever may not be able to process the PCM signal of the computer. Does the reciever show a PCM or DOBLY DIGITAL display when HDMI is hooked up to it?

I had the same problem with my xbox 360. I was able to fix the problem by disabling the Display Discovery setting on the xbox.

Component (i.e. TV) should be connected to plug labeled IN (signal IN receiver).

www.powertoolspares.com sell parts for hitachi nailers.

Unfortunately only the higher end Onkyo Reciever pass audio over HDMI for sound. 605,705,805,905 exc. Your reciever will carry Video over HDMI but you will need a digital optical cable for sound.



thanks.

If the unit will not leave standby I would remove all power, disconnect *all* connections at the back, reconnect to a power source and try powering on. This will eliminate any connection causing the Onkyo to stay in standby due to a short. If it still will not enter power-on mode, you may want to look at the power source (is it properly grounded?), but beyond that the unit probably needs to go back.