Hi murple_1, these instructions, will help you "reset your password!" Part 1 Part 2 To Reset: "Password" Hold - [Down] "Reset Button, in the back of the D-Link for 15 - 45 seconds" "This will {Reset the D-Link to Factory Settings}." !Important: "Take a 'moment to rate the help', so I can get 'credit' for the work. Thank you!" - paul7of9
To Reset: "Password"
Do the following:
This 'comment' is for FixYa! So my understanding is; -10 is {subtracted} for "Not Helpful: Solutions!" But! When the "Solution is Very Helpful! = 5 or < LESS!" ? Is this "Correct"!? I have another ?Question? Do a number between a (100 to 1000) people respond quicker, and more to "Solution that do not help!" In comparison to the "Solutons that do?"
×
You will need to do a factory reset on the router by holding the "reset" button on the back while the router is plugged in for 5-10 seconds (the LEDs will indicate that the router is restarting).
After you've reset the router to factory defaults you can log into it by opening a web browser, going to http://192.168.0.1, and using a password of "admin" (there is no username).
Hope this helps
Please rate this solution, thanks!
Hey there,
You can reset your router back to factory default.
Look at the back of the router:
http://images.dlink.com/new/products/WBR-1310/WBR-1310_back.png
There's a very small button on the right hand side labeled "reset".
While the router is plugged in, use the end of a paperclip or ballpoint pen and push in this button, holding it pushed in for 10 seconds.
Let go and then let your router reset and start up again, this usually takes about 3 minutes.
It should now be set back to it's default settings.
Hope this helps!
Please provide more information as to you issue such as :
a. model number
b. year manufactured/firmware updated
c.Are you using router wirelessly or hard connected.
d. You have checked the user manual 1st.
e. You have confirmed that you have connectivity with the ISP ( internet service provider)
f. uninstall/ reinstall the router software with the CD provided from the manufacturer.
When you boot up to the log in screen type in administrator as user to log in if you cant log in
during the boot up process you will see on the screen for a short amount of time press a certain key to enter set up
Press and hold that key during the boot up process to enter BIOS scroll down to set user password or supervisor pissword you can change or remove your pissword from there
also
click start control panel user accounts
on the users tab,click the name of the computer administrator you can change the password there
hope this helps
164 views
Usually answered in minutes!
×