Zanussi aquaius DE 6855, starts off ok ,rinses ,but then stops and wont pump the water out and the lights start to flash on and off. Any ideas

May try resetting the breaker turning off turn on

check for blockage

Some appliances malfunction can be displayed in hexadecimal or in binary code.
So your device is defective and shows you what's wrong. You have to count how many times flashes red light and how many times flashes green light. Red light shows the first error number and green light the second error number.
For example: you forgot to close the door and you started washing machine. After some time (timeout) will generate an alarm. Four times will flash red light and once the green light which means error code " E41 " or "Open door"
" E20 " means "No drain water"
" E10 " means "No fill up water"

Dado

I had the same problem before, but removing the kink in drain hose does the trick. Maybe yours is more complicated but try it.

Hi

The issue can either be with the unit not draining properly or the timer/electronic board itself has gone bad & should be replaced. First clean the drain hose and the drain pump for any clogs, you can do this by taking off the bottom access panel. After cleaning if still the issue is not resolved then the timer/control board has gone bad and needs to be replaced. Hope this helps...please post back for further assistance.

Daniel

Hello Paula,
Do not know how many flashes but 1green/1red = 11 water pressure low.
2green/1red = 21 blocked filter or pump fault.
You would be best firstly checking the filter and make sure it is clean and pump turns.with water drained and filter out shine torch into filter put on spin/drain and see if pump blade spins if not then try and turn with long screwdriver to free out any debris then refit filter and check for leaks and try donnt fill fully until you are happy it can drain water.
Hope I was of some help.

Good Luck

Same Problem Here - I Noticed your Post is quite old - Please did you solve the problem my friend..........???
[email protected]

DEFF BRUSHES.JUST HAVE SAME PROBLEM MYSELF NOW AND TOUCHED BRUSH HOLDER SLIGHTLY AND RESTARTED..

You need to reset the computer on the bottom. Had the same problem with mine. The Blinking led means the heating element is bad and will not operate.

Yes if you remove your soap draw and take a look inside you will see that there is all residue built on the top part of the internal draw, Either you can jet wash it off or replace the soap draw,,

this should solve your problem.. if that does not work then one of your solinoid valves at the back is faulty...