I need a cable to connect my rz-ba10 box to my tv. where can i buy one?

Have you tried selecting the right input with your remote?

Hi!
Please find your solution for the problem here:
http://www.bc.edu/offices/help/meta-elements/doc/articles/html/TV-cablesetupguide001.shtml


Thanks

easiest way to stream to tv is with a cable. depending on the make of the tablet , you can buy hdmi micro cables to connect to tv. doing it wireless you will need a box plugged into the tv that has DNLA capability. both are available to buy.if you go for an android tv box they have that but also have XBMC which will allow you to watch any movie/tv programs/sports etc for free

Hi,
Samsung SyncMaster 2233BW does not support TV / Cable input (RF Connector).
If you wish to connect Cable to the LCD, you have to buy a TV Box and connect Cable with your LCD through TV Box. (Cable TV to TV BOX and from TV BOX to LCD)

Hope it helps! Good Luck! Thanks for using Fixya!
CreativeTECH

your output cable is in the back of your t.v. there is a color designated on its hole then you have to buy a a cable in any electronic shop like components cable or hdmi cable try to read the back panel of your tv

Can you tell me what type of TV you're trying to connect to your set top box? Also, are you looking to buy new cables or use cables that you already own?

You'll need to purchase an HDMI cable and use that to connect your hd box to your tv. Your tv should have several HDMI connections on the back to facilitate the hookup and you will not have a true HD picture without that cable. You can buy this cable from the same place you bought your tv or www amazon.com as well as many other electronics supply stores, hardware stores, or places like Kmart, Walmart, Bimart, etc. You can also buy a multi port Rh connector box that you can run multiple components through and just push the corresponding button for the component you wish to operate.
Hope this helps and please rate my solution!!

hi would you like to sell your box as i need one ? thanks paul

The antenna connects to the ant jack on the digital converter box. The cable you are describing goes from the tv jack on the box to the ant jack on the tv. If this does not work we will need more info. Hope this helps.

take off back panel and adjust the V12(A) adjuster wheel on the power board it adjust the gas flow to the screen is should light up your screen