How place "cavalier" for maxtor

http://www.techadvice.com/images/company/maxtor/style_a.gif

Here take a look at this pdf:
eshop.macsales.com/Tech/manuals/idehdsettings/Maxtor72.pdf

So If this is layout " : : : . : "

then...

slave ----------- " : : : . : "

master -------- " [:]: : . : "

cable select -- " :[:]: . : "

Take a look at this pdf:
eshop.macsales.com/Tech/manuals/idehdsettings/Maxtor72.pdf

So If this is layout " : : : . : "

then...

slave ----------- " : : : . : "

master -------- " [:]: : . : "

cable select -- " :[:]: . : "

MAXTOR: no jumpers --> Master
one jumper --> Slave
two jumpers --> Cable Select

For use as slave there is no jumper connected. (Master on/slave off0

Select the maxtor HDD as master by setting the Jumper to the extreme left of the hdd; i.e. next to the data cable.
Remove all jumpers from the other HDD which you want to put as slave.

maxtor n256 how do i set the save thank you

There is usually a diagram on the drive showing the jumper configuration.

The first jumper goes up and down on the two pins just beside the IDE cable slot and the other jumper goes across the top two pins next to it

On the back of the hdd you will see a row of little pins in groups of 2 vertically. It will be marked either right above the pins or on the top of the hdd above the pins, ma, sl, cs. The setting for slave is sl. Put the plastic jumper cap on those 2 pins & it is set for slave. Hope this helps & please remember to rate my answer. Thanks.