Started printing first 2 pages fine then stated print one line of symbols and letters on each page

Printing half a page with an Inkjet machine is not normally a computer issue. So windows 10 would not normally have any effect on the printing for a printer that has been accepted by the Windows 10 Operating System. If there was an issue in the software it would be printing gibberish or not printing at all.

Printing half a page is quite possably something stuck in the printer stopping the ink from getting to that half a page if it is printing down once side but not the other.
Printing half a page being that the top half is printed but not the bottom half (Or the other way around) it could be an air bubble in the feed line which can be cleared with a printhead clean or two.
Printing half a line rather than a full line such as the top half of each letter is clear but the bottom half of each letter is not visable is a blocked printhead. A couple of printhead cleans can also fix this.
Also check to see if the printer is not confused and actually has empty cartridges even if the printer thinks they are full. Brother printers can easily get confused about ink levels. If the cartridges are actually empty, replace them and away it should go again.

Hope that helps

Just DELETE Your Installed Printer,And Re-install with PS drivers.

Us the printer stand-alone. Go to Maintenance do Printhead cleaning, Nozzle Alignment and Calibration. After that try printing a Test page.

IMPORTANT: You must have firmware version 6.011998 or greater on your printer. To upgrade firmware go to www.kodak.com/go/downloads.
TEST PAGE
Press the Menu and OK keys simultaneously.
The demo image will print.

- If the page still blank contact 1-800-421-6699 they can send you a printhead replacement.

This could be a driver issue. Without knowing exactly how your printer is connected to the network I'm making a rough guess here.

There is a Universal HP Printer driver that could be tried as well as the PCL5, PCL6 and Post Script drivers.

I've had issues with the PCL6 drivers before doing this and I usually install the PCL5 drivers instead.

This sounds like a corrupt print driver. Try uninstalling and reinstalling the driver.

Clarification >
Whats the operating system on your computer

Solution >
Try to uninstall the printer driver again and download a driver from the epson website

http://tech.epson.com.au/downloads/category.asp?sCategory=Multi_Functional&id=styluscx3900&EmailAdd=&CanEmail=&SelOS=Y&MetricIDReturned=2865324&sCategory1=Multi_Functional

> Select the operating system and then click on search / continue / then select driver and utilities suitable to your computer.

Hi, Make sure the rear cover is closed. 2. Usually when you get misc symbols on the printed page the machine couldn't recognize the print job. I would try printing something from another file and see if the problem occurs.

Had similar problems to this after changing the printer driver.


Suggest latest printer driver from HP (for your operating system) - better to use this than the one that is provided by Mr Gate's crew)

hi i am having roughly the same problems i use cad and have not even managed to print that far yet what windows are using?