At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Please mention in detail the nature of the fault and yor competance to repair . You will need to check from the program module to the execution of the different modes of the program.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It is simple . Before the process make sure the the power is off .. There screws on the back after removing them you can lift the top n easily remove the none working ones . You can buy the spear ones online or local shop . I have done it myself or search YouTube with model number youse come a cross with repair option . Good luck .
This unit is a direct drive unit which means that the speed is controlled electronically. A determination fo the cause for the behavior is required. This is not a DIY repair. There are feedback loop circuits as well as "driver" circuits, either of which could be the source of the problem. The parts required for this repair should not be expensive (under $25). I would suggest that you seek professional assistance for this repair.
u have a safety switch theres an arm on the door that when the door closes it goes into a hole and pushes a switch the arm may be broke or the switch may be bad or it might be as simple as a wire has came off of the switch but if not unplug washer and take wires off he switch and check continuity across terminals when the switch is pushed in if alll this fails u may have a bad adgitator motor lets just hope its the switch thats a cheap and easy fix
sounds like the jet-dri dispencer is leaking and repair is req unless you start to purchase the hanging basket type of jet-dri it will disolve through the normal process don't add anymore liquid jet-dri unit one or the other is done
Getting hot when not started is a great concern. I have a few ideas why, but this is a fire hazard and I would suggest unplugging and either getting help or replacing. That said, there here are a few suggestions. 1) if the element is shorted to ground, it will get power to one side of the element and heat though ground. This, again, is serious. 2) if it heats forever and doesn't get warm enough to dry, this is another indication of an element that is not working up to power. Not getting 230 across the entire element and not getting hot enough to dry. 3) Many times when a dryer runs too long, the air flow if blocked by the vent being plugged or some plug withing the dryer itself.
Again, I am very concerned about this problem and suggest you not use it until it is repaired. If you want to check the element, it is fairly easy, but unit will need disassembled.
×