I am getting a EFO then E10 error message after I start a load of clothes...which means I have to cancel the load.

E10 error is water inlet hose clogged. Screens should be cleaned out. Hot and cold. If you can't do it yourself get someone to help you.
Good luck.

looks to be a long fill error. check to make sure your water supply is turned on, and any water coming through the hoses.

efo enter prblem what is the problem

Frigidaire, Zanussi, AEG, & More....

EFO = Filter Blocked (low flow) and it is accessible from the bottom front of the machine.

1. there is a blockage in the filter or drain hose.takes too long to drain out.
2. over dosing of powder or liquid. again can cause an air lock in the pump which slows the drain pump down.

Check the filter and drain hose and test again. this fault will only come up at the end of a cycle.
You do not need to reset the machine to get rid of the fault code as this is automatically deleted.

Run an empty load with no detergent in an attempt to get rid of the code.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question!!!!!!!!!

Frigidaire, Zanussi, AEG, & More....

EFO = Filter Blocked (low flow) and it is accessible from the bottom front of the machine.

1. there is a blockage in the filter or drain hose.takes too long to drain out.
2. over dosing of powder or liquid. again can cause an air lock in the pump which slows the drain pump down.

Check the filter and drain hose and test again. this fault will only come up at the end of a cycle.
You do not need to reset the machine to get rid of the fault code as this is automatically deleted.

Run an empty load with no detergent in an attempt to get rid of the code.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Frigidaire, Zanussi, AEG, & More....

EFO = Filter Blocked (low flow) and it is accessible from the bottom front of the machine.

1. there is a blockage in the filter or drain hose.takes too long to drain out.
2. over dosing of powder or liquid. again can cause an air lock in the pump which slows the drain pump down.

Check the filter and drain hose and test again. this fault will only come up at the end of a cycle.
You do not need to reset the machine to get rid of the fault code as this is automatically deleted.

Run an empty load with no detergent in an attempt to get rid of the code.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

spoke with electrolux and they tell me that it is over sudsing problem. The washer must use HE detergent or use only a the lowest amount on the cup.

Clogged drain pump.

I don't see either of those error codes in the frigidaire technical data for this model. You can look here:

http://www.frigidaire.com/support/ResultsPage.asp?strModel=atf6000es&User=&Search=Search

I've heard EFO has to do with oversudsing so if you're using HE soap use less, if you're not you should switch.

It is simple. The wrong soap or too much soap will caused EFO to flash. I overfilled the machine with soap by accident. It started flashing with EFO and I went nuts. What could be wrong with it now?! Too much soap or not the right kind of soap will cause this problem.
Plus, I found a sheet of paper that gives the codes.

This is better than when the strainer plug gets filled up and you have to take the machine apart to clean the little strainer.