The picture on the T.V is bowed toward the center, with the top and right side bowing the most. The bottom and left side are not so noticiable, and there is double picture(the 3 colors aren't lined up right)
Replace Both of your STK ICs convergence ICs STK392-110 use 150s Better ICs Call Mats 1-800-628-1118 Also RK42 RK46 RK48 RK50 RK54 RK58 RK60 will have to get back to you on resistor values
After you replace Both ICs and Resistor RK42 3.3ohms RK46 1.8ohms RK50 2.7ohms RK54 1.5ohms RK58 3.9ohms and RK62
2.2ohms you then can adjust convergence if Needed by pulling off Front bottom Panel Board Their in Front of your convergence Board is a small blue contact switch with TV on press for 5secs then release you should now have Convergence Pattern showing!
Then you may need to just resolder your ICs if it corrects itself at times,and resoder any poor connections you see on Board .
×
Usually consumer described bowing is bad solder connects
on pins of convergence IC's. If the effort is made to pull the center PC board out,then replace both Stk392-570 IC's for
durability.
Note: V-Pin amp and pin out relates to left/right side bowed-in
issues,a problem not usually found on your model.
194 views
Usually answered in minutes!
Same problem. Is it similar to "blue line won't adjust" post for the same TV? Looks like there is a suggested solution but that one person tried it and it did not fix the problem.
I also noticed the TV used to correct itself (sometimes on its own, sometimes after a hard whack on the side), so wondering if it's something mechanical? I'm about to open it up and see...
×