Top and bottom of picture in center of screen dips like a bow tie

Yes it should, although your model will also require replaceing the two 5 amp pico fuses F9A04 and F9A05

It is a convergence problem, probably one of the convergence ICs has blown and must be replaced. Call the number in the last pages of your user manual to get repair service in your area.

This is probably the notorious "light engine" problem that all of these Sonys of this design run into sooner or later. It is usually more expensive to repair that what the TV is worth, sadly. A Sony authorized repair center can confirm this.

Projection TV sets have several common problems listed below.

Problem #1) Convergence

Symptoms:

• Screen Looks 3D
• Colors wont align
• Screen may look distorted
• No Audio/Video - TV makes a chirping sound.

Problem #2 CRT Fluid has clouded over. Symtoms

• Dull looking video
• White looking video
• Halos around objects
• Red/Orange looking video

You can see some examples and find a fix here...

http://www.fixya.com/support/r2861467-solution_video_looking_whiteish_dull

go to hatch screen adjust all colrs to make white color boxes , also adjusts linear lines

I´m changed the canon to TV projection the green and is go out the convergencia above and
side right I don´t know how iter in the menu inter could you tell me how it these. thank you..

the stk's are the STK392-110 http://nte01.nteinc.com/nte/NTExRefSemiProd.nsf/69d5aa3584d015ce85256e780056e56f?CreateDocument
but you will also want to check all resistors on the STK's for values within 5% - 10% of said value

This is a convergence problem that you can fix if you can solder. Let me know if you wish to attempt the repair and I'll post additional details and instructions.

Dan

Your convergence chips and convergence resistors are going bad. When they fail the screen colors will look distorted/3d looking. Another symptom is one or more colors can't be converged using the convergence menu. You can purchase the parts over the internet. Just make sure you get Sanyo brand convergence chips and the correct flame proof resistors. You can also check the site www.TvRepairKits.com for a kits.  Just make sure you replace both of the convergence chips and all of the convergence resistors. 

Are the convergence controls also out of adjustment? Please respond to this same post and I will help you. If you could post a picture of what the screen looks like that would even be better.