The lights stay on. Never had it do this before. have turned off the switch and reset to 1 min vs 5 min, and it still stays on. any suggestions?

I just had my new opener today. try this:
1. press & hold the LOCK button until the lights blinks.
2. if it is a single blink, the timer is 1.5 min.
3. if you repeat step 1, blink twice means 2.5 min.
4. if you repeat step 1......., 3.5 min
5. if you repeat step 1......., max is 4.5 min

generator field not switching properly.P0622
Internal powertrain control module fault condition detected (failed memory check ) p0601.
Sounds like its time to replace ecu pcm. But try resetting it first. Remove negative battery cable and turn key all the ay for 1 min. Then pull positive off and touch the negative cable with positive cable and hold for 5 seconds. Make sure they are not touch battery terminals at all. Good luck

what do you have your unit hooked to too power up straight off the battery or thru a power switch if thru a switch hook it straight to bettery

Hello Gerald. Each switch has a function. the the test-1-5-10 allows you to set it to test or an on period of 1 or 5 or 10 minutes. The off-3-6-dusk to dawn allows you to turn it off completely, operate from dusk for 3 hours, operate from dusk for 6 hours or operate from dusk to dawn. By operate I mean turn on and then stay on for the number of minutes you set it to with the other switch.

what's nice about the test setting is that with it allows you to check and b sure that the light will come on during daylight by setting the one switch to test and the otner to any setting but off.

If you leave the 2nd switch set to off the first switch will not allow you to test it.

Joe

Your PS3 may be overheating. Check the exhaust of the ps3 where the hot air comes out for any excessive dust. If you have a 60GB PS3, you can blow them out by turning off the PS3 by the back switch and then turning it on using the back switch with you finger on the eject button. The PS3 should beep 3 times and your fans should go at full tilt for about 30sec to 1 min.

I would definitely go after the brake light switch under the L/S dah at the brake pedal . Sounds like it might be sticking. Hope this helps

Try this.. Turn key OFF.. Hold trip/mileage reset button.. While holding button , Switch car on ( but dont start ).. Continue to hold button for @ least 1 min or until ya see XXX's flash in the mileage lcd.. Lemmie know if it works.. I reset hundreds a week and get them confused.. Thanks

Hello nicolastran,

I gave this advice to someone with this same problem so here it is again:

It sounds like your shutdown circuit is being activated. This is due to excess current being drawn. This usually happens in the High Voltage section of the TV or one of the deflection stages. Due to the nature of this problem I would suggest that you take it to a local TV repair shop or have a TV repair person come out and take a look at the issue. The HV section is dangerous and should be dealt with by a qualified TV repair technician.

Thank you,
I hope this helps

Shuttle83

check out ctechnicians.com and find error codes