When washer is spining it makes alot of niose...is it the belt..

About 90+% of the time when a dryer won't spin it is a broken/slipped belt.
If the dryer makes some niose when activated, then the motor is turning, which exonerates the
motor, leaving just the belt - the belt may have slipped off a (possibly broken) pulley.

If your washer is not spinning ! You first need to drain it. Then underneath your washer you will find your drive system. It will consist of drive belt, drive pulley or pullies and motor. Belt could have come off , if so check the condition before reinstalling, also some times from overloading the belt will spin on the pulley which will make it hot and thanks to the manufacturer the pulley is likely plastic. Parts supply shops best source for belts and possibly pulley though sometimes they want to sale you the whole motor with pulley which you don't need. If so uae internet to find your pulley probably under 10.00 dollars. Hope this helps.

Make certain that the spin speed is where you want it (e.g.: high spin). Also, make certain that you aren't overloading the washer. A heavier load will slow down the spin.

You may have a worn drive belt (loss its tension on the pulley). Contact an appliance service company.

it might be out of level and the motor supports might be wearing down

a belt has snapped or came off or the motor and brushes are damaged.

belt burrt out advise new belt or new machine

• Hi,
• Try these out:

1. Balance the load
   
2. Level the machine
   
3. Inspect the water pump for a blockage
   
4. Inspect the coupling
   
5. Inspect the transmission
   
6. Adjust the drive belt tension
   
7. Check the motor bearings
   
8. Check the drum brakes
   

please rate my suggestion...

Your motor coupling is broken. You machine does not have a belt. this part does the job of a belt. it is between the motor and the gearcase. The part # is 285753a if I remember correctly it cost about 20 bucks . If you are handy you can do it yourself and save 150 in labor.

yea sounds like a bad motor coupling ( this machine equivelent to a belt).

Replace the loose belt. Regarding the dripping oil,look for the defective shock absorber. Good luck!