Canon copier/ fax imageclass 2220: error #0322

Hi,
First Unplug the printer for 10 minutes. Then start your printer it will work fine.
Then execute eprom clear in Test mode.

If you still face the problem then there is a bad solder connection or a power surge. Loose wire is always possible.

Hope this helps.

Shane

Hi,
this means that you have problem with fixing assy. Best solution would be to replace fixing unit.

And,... did you consider to buying new one,... try with Canon image runner 3225N. Its a NORMAL copier. :-)

Sounds like the fixing film has gone bad..... and or the dc power supply could have gone bad in it. i would call a service tech to come out and take a look at it if you haven't already done so.

I believe the sender has a digital phone line, which is very unreliable.

Hi, please get new driver here: www.driversdown.com/
www.nodevice.com/driver/company/Canon/Printer.html
www.usa.canon.com/cusa/office/products/.../hs_1200ts

Jay kbxlz

make sure the the phone line which you using having ISD calling facility in dialing 1 st you try that no by dialing with the normal phone.

Set your canon on factory defaults using front menu button. And then set fax again.
may it helps

see if you have fax line(conect a telefone in the line to see if you have tone) or if the cable is conected.

#0018 indicates there was a problem with dialing, but it should show for sending faxes only. Since you can neither send nor receive faxes, and are getting a message saying "no signal", make sure that the phone line is still securely connected to both the L (line) jack on the machine and the phone jack in the wall. If it is, plug another phone into the accessory jack on the machine, and check to see if you are getting a dial tone. It seems like the machine is not able to communicate through the phone line.

E000 is a fixing unit problem. It could just be needing to be reset or replacement of the fixing unit or if that is not the fix it may coast more then it is worth.