One of the lightbulbs in the refrigerator is out. There is a guard over it that I can't figure out how to remove.

get boyfriend that can change a lightbulb and maybe he can figure it out

I have a Husqvarna Classica 100 and need to lower the lightbulb guard so as to change the bulb. I have read the manual, but still cannot figure out how to do it. Any help would be greatly appreciated.

sometimes the manuals don't cover every thing that they need to .

Hi, To acess the light. Remove the plastic cover over light carefully. Replace bulb and your good to go.

HI change the main board its about $150-200. Will fix all your problems except the lightbulb would be a lightsocket problem or the bulb you put in is bad, or door switch.


Sean

it s a little hard but remove the lower crispers and the is a light cover idem 259 remove it and the light is there . use a 40 w appl bulb only any larger will not fit and will melt the plastic cover .. mm hope this helps . feed back pls ..

1. Remove front wheel well front half splash guard, each side. There are about 2 screws and the guard pulls forward to seperate from the rear half.
2. After removing the splash guard, you can access one screw that attaches the front fascia, each side.
3. Then about 6 plastic push pin type screws along the bottom, underneath.
4. About 5 push pin type screws on the top.
5. Fascia should then simply pull forward. It is a bit bulky and an extra pair of hands is helpful.
6. Then there are 3 screws to remove the headlamp assembly. Unclip the wiring harness.
7. Then 4 screws to remove the bulb access cover plate.

u can find on the sides or on opposite side or the door......or some will have only one bulb or light source as u know its in the top......

Most shields push in then down to engage them so push in and lift straight up. They are tight so will take a little pressure to remove. They have 2 or 3 tabs.