Garage door keypad code... how do I reset it? I have a craftsman
Garage door keypad code... how do I reset it? I have a craftsman
Http://download.sears.com/own/53985e.pdf
try this website page 36
My outst9a wont work with chamberlain opener 2018
SOURCE: Resetting a keypad for a garage door opener.
simple , i was a sears installer for 10 years installing garage door openers so your in luck , just locate the smart button on the machine ,it would be on the back or if your looking from the back at the back ,it could also be on the right side depending on if the machine is a sideways mounted machine or frontmount, after locating this button which maybe green/orange /or purple in color also depending on your model ,the newest sears machines are purple buttons ,and 5 years ago they were orange and the older ones would be green ,...ok so after you,ve located it just push it once and you will see a solid yellow indicator light come on , now go over to the keypad and put your 4 digit personal code in after that press the enter button AND HOLD IT for around 3 seconds , at that time you will see the lightbulbs on the machine go off and then click back on , and THAT,S IT! plain and simple , now go proramm your remote! hope i was of help to you , and if i was leave me a nice rating Sincerely Glenn mayer
SOURCE: keypad garage door opener will not operate
what keypad are you using with new opener? Frequency has changed. can't use old one. you probably never needed to change things; just needed to follow proper coding procedures.
SOURCE: New code entry does NOT override old code on Craftsman 315 keypad
yes. Press the learn button for 8 seconds to clear the remote memory. Reprogram all remotes and keypad
SOURCE: programing garage door opener
Hold the button on the remote and press and immediately release the smart/learn button. Do this for each of your remotes.
For the keypad press and immediately release the smart/learn button. Walk over to your keypad and key in your 4 digit code and press enter.
If these instructions don't work you have a bad logic board.
32,517 views
Usually answered in minutes!
how do i reset the pass code
the wrong code was entered too many times and it didn't open the door.
I hit the learn button and then entered a new code and hit enter but the lights didn't flash and I did not hear any clicks. Then the receivers stopped working so I had to reactivate those.
I replaced the 12 volt battery on the keypad by craftsman and tried to enter a new code again within 30 seconds and hit enter. NO go. Please help! Thanks~!
Very helpful, tips to reset password was made easy. Thanks Poetry
×