Need schematic to remove top - Whirlpool Washing Machines

There are a couple of things you can try checking. 1st take the top off and check the 3 bolts to see if any of them need to be tightened up. 2nd remove the front plate to see if you may have a staple jammed in there. Here is a schematic link if it helps with the breakdown: http://www.rvevans.com/Technical-Services/Tool-Schematics.aspx just click on the link to find schematics

Look inside the service panel, manufacturers have been getting really good about putting the service information into packets inside of machines.

You can find a link to the schematic below. The schematic points out where all the screws are on the H3000. You can also find any parts that you need to replace.

H3000 Parts

94,95,96,97........The top can only be removed if the whole dash is out. Due to it being assembled upside down. Hope this helps

the brake light switch is on the top part of the pedal unplug electrial connection remove clip that holds switch on pin remove switch and reassemble

theres a wiree diagram under the top console, look directly over the console, you see 2 phillips screws in both corners, remove them and the console will flop back and you can get the wiring info there

Belt needing to be replaced is obvious.

As for a schematic of the motor, I think what you are really needing is a wiring diagram and schematic of the complete washing machine. Most often, there is a paper one glued to the inside of the removable panel on the back of the washing machine. Either there, or inside the control head on the top of the washing machine.

Please include the specific model number in any replies.

There is a schematic under the cover of the elecrtrical connection box. Remove the top of the box ( typically one nut on top of the pressure regulator) and look under the cover you removed.

Good Luck

No need for a schematic, there are two kenmore dryer belts, 'full size' or 'apartment size', if it is a belt you will be able to here the motor racing unloaded, turn heat to cold before testing, dont want to blow a thermal fuse.

Kenmore dryer comes apart from the front,

• UNPLUG dryer 220V is not fun
• remove the lint screen
• remove the screws under the lint screen holding the case top to the screen holder
• with a putty knife or other blunt blade release the catches at the front corners of the top and raise top
• remove screws holding front of case on, from inside the dryer
• remove door switch cables
• lift front of case off and set aside,
• can reach motor, belt, felts and rollers.
• broken belt will be obvious, lying on the floor

If belt is broken, examine rollers and felt bearings for wear, stuck rollers or no felt left, is the most common cause of belts breaking, extra tension is required to spin the drum, If damaged replace them, they are cheap and easy to do, and it woud be no fun if another belt broke quickly

reasemble after repair in reverse order.

http://www.searspartsdirect.com/partsdirect/retrieveModelAction!retrieveModelDetails.action?modelNumber=GGW9250PL0&productCategoryId=0151200&brandId=1198&method:retrieveModelDetails=x

This link shows the blow ups for the different area's of the machine. The schematic would just give you a wiring diagram, but if you need that as well, remove the 2 1/4" screws on the top panel towards the rear. Slide the top panel towards the rear and lift up on it. Once the top is out of the way, you should find a schematic on the right hand side panel. If it is not there (as with some duet models), remove the lower front panel (2 1/4" screws along the bottom of the panel) and the schematics will be attached to the inside of the panel itself.