I need to replace the bulbs in this microwave oven. Do you know where to find replacement bulbs?

The cooktop light bulb(s) is(are) located on the underside of the microwave oven, and is(are) replaceable. Remove bulb cover screw, and open the bulb cover. Replace bulb, close bulb cover, and secure with screw. Cavity light: The cavity light bulb is located behind the vent grille at the top front of the microwave oven, under the bulb cover, and is replaceable. Remove 2 screws on the vent grille, tilt the grille forward, and lift it out. Open bulb cover and replace bulb. Close bulb cover, replace vent grille, and secure with screws.
For more information, your owners manual can be viewed here (scroll to the bottom of page 4):
Maytag MMV1164WB Owners Manual Page 4

Good Afternoon Friend,

I understand that you want to know how to remove the cover on your Frigidaire microwave, model# FGMV205K. There are two different covers that you are able to remove for access to two different light bulbs.

If you are trying to change the Microwave Oven Light for inside your microwave:

1)To replace light bulb, first disconnect power to your microwave oven at the circuit breaker panel or by unplugging it.

2)Remove the louver by removing the three Hood Louver Screws.

3)Push in the upper tabs and pull the louver away from your appliance.

4)Remove the light bulb and replace with a new 20 watt light bulb. DO NOT USE BULB LARGER THAN 20 WATTS.

5)Close the Oven Light Cover by carefully pushing into place. Push the louver back into place (engaging both the bottom and top tabs) and change to hood Louver Screws.


If you are trying to change the light bulbs underneath your Microwave:


1)To replace light bulbs, first disconnect power to your microwave oven at the circuit breaker panel or by unplugging it.

2)To open Light Cover, remove the screw on the light cover.

3)Replace the light bulbs with new 20 watt light bulbs. DO NOT USE BULBS LARGER THAN 20 WATTS.

4)Close the Light Cover and secure with screw removed at step 2.

If further troubleshooting is needed, I ask that you please let me know the error codes displayed on your appliance. Hope this is helpful.

-Best Regards-
WP

hello chris microwave is an american model
I found the tube/bulb you looking for is like the picture and called quartz grill tube and can be replace by similar voltage 120 v

You should try to at least find the same wattage. The light bulbs are not dangerous safety hazards if they are made to fit microwaves.

I save any microwave i find thrown out. I take the parts off of many.. and yes they use a microwave light bulb. I don't know who sells them... likely an appliance parts place.

That exact model number is not showing up, so you may want to check the tag on or in the unit and look here for parts.
Most of the models in this class of ovens were not really made to be serviced, so GE only makes the turntable parts available.
It also sounds like your bulb is an assembly - the socket and bulb and one piece.
So your local appliance parts store should have a generic replacement for it. You should take the bulb.
Be careful when disconnecting the leads.

if this is a counter top modle this is no problum, unplug it!!!
open door look for the light hole vents, ( that is where the bulb is )
you will need to unscrew the outer casing. noproblum there is nothing but reguler insalation in side and a area where the bulb is. replase it you can buy them at any hardware store,

if is a under cabinet there my be a axes door if not will need to take down,

hope this helps.

p.s. 1st time i that there was all kinds of things in side but not

I am in need of a Jenn-Air JMC7000ADB (black) microwave, so if anyone gets tired of trying to solve the problem, I will buy your microwave from you.

Call Mike at 317-557-5352 or e-mail [email protected]

Thank you.

Most electronic control boards have undersized circuit wires that can't handle a catastrophic lamp failure. The circuit trace will open like a fuse. If you or someone knows how to use a soldering iron, this can be repaired.
1. Remove the top grille. (Two screws on top)
2. Remove screw above button panel. Push up on panel to remove.
3. Remove circuit board from panel. Look on reverse side for open circuit trace.
4. Repair circuit trace...lights work again....

If you need further assistance, let me know
Regards,
reg501

most microwave ovens built in the last 20 years do not have an
access panel to the light bulb. you must remove the screws on the back of the microwave that hold the outer sleeve in place.
Then pull upward and backward on the sleeve to disengage it
from the front lip of the chassis. the light bulb should be close to the front of the microwave behind the control panel. Some lights
are not unscrewable from the socket, but the socket and bulb
come as an assembly.