Slow leak out the bottom of the WHirlpool Duet front loading washer on the front right side as you are looking at the washer

First, make sure that the washing machine is not too close to the wall behind it. This could crimp the drain hose & force water out at the connection behind the machine. This could also crack/split the washer machine's port (to which the drain hose attaches). Second, check the hose clamp for a secure hold at the washer machine's port, & check the drain hose for leaks & for insertion in the drain tube at the wall.

there are three screws under the front of the panel. make sure its not leaking from the door and running that way. if the bellow or door seal is damaged or bent or torn it will leak. please dont forget to rate me thanks

Where is it leaking from ?

---

Please dont forget to vote if you liked my answer

thanks

empty the washer. then remove the bottom panel of the machine.put some water in it and see if the water is leaking when it is filling or full.I have seen a small hole in the tub just behind the bottom counter balance where the mounting bolt goes you may need to use a small mirror to look under there.

you can remve a few screws(3) across the bottom of the unit.( just above your "add-on" drawer. 3 torx 20 screws and after removing the acess panel youll get abetter look as to where exactly you water is coming from

you can remve the lower acess panel (3 screws along teh bottome front panel) too look to see where it coming from. the top also removes with 3 screws along the top of back panel

Check the easy stuff first, fill hoses tight?- drain hose cracked? Failing those checks, cut a piece of cardboard slightly smaller than the size of your washer. Slip the cardboard under the washer and run a short load. Look carefully at the water mark on the cardboard. The mark on the cardboard the water leak will leave, will help you tell from which side or front to back the leak is common from. This will help point you in the correct direction to look for the trouble maker.

thanks.

check around and under the rubber front gasket for any trapped items,
if flooding happens open the bottom access panel (3 screws on bottom front) and look for leakage at that time , there is a access door safety switch to the top right that has to be closed to let the unit run.
blow some powder in the bottom to show the wet spots and/or to trace when they happen again.

remove and clean any obstruction or deposits around the inner door seal use H.E. detergent over sudsing can cause that too.

hi there i would check the softner part of your soap drawer first for blockages, you can let me know