I have a remote diamond vision vcr/dvd

goto this web site and click on diamond

http://www.dvddemystifiziert.de/codefree_en/codefree.html

The only Diamond Vision Codes I can find are these.
Hope one works for you.

0622, 0496, 0810

Have a nice day!

I have the exact same problem with a 20 inch tv of the same brand , Maybe possible recall i dont know what to do

SOLUTION: I had the same problem with a Diamondvision DTV3913. After trying many universal remote controls, I found one that worked. The RCA universal remote CRCR3273 / CRCR3373 (also referred to as RCR3273 / RCR3373) was the answer. It has 3 codes (1232, 1233,1234) for DiamondVision TVs and the first one worked. It gives me all the control I needed including the hard to get ones like input selection, main setup menu etc. It also has codes for DiamondVision DVD players and VCRs. I see it at BestBuy for $8.

This is a comon problem, look up your code again, but notice combo, look at just the tv, now the vhs, try all of these codes

I’m happy to assist further over the phone at https://www.6ya.com/expert/james_1cb31da1bc8c6102

They are Audio and video inputs that go onto the same colored jacks on the tv (if tv is too old, try using the vcr or rf modulator)

Try ordrer the original remote contrl by Tv's manufactory. Aleixo

This must be a duplicate post. And because I'm not sure which one you'll check I'll just post the answer here too... Diamond vision is a little pickey with handing out their code access. And Rogers doesn't have a whole lot about accessing components like DVD players. But try this: 1. Turn on DVD player 2. Press the AUX button at the top of the remote 3. Press and hold the SETUP button until the LED light blinks twice. 4. Press 9-1-1 in sequence, the LED will blink twice again. 5.Aim the remote at the DVD player and slowly alternate pressing POWER and AUX. Stop when DVD turns off. 6. Press SETUP to lock the code in memory. It may take several minutes of alternating between POWER and AUX to find the appropriate code - be patient... If after ten minutes you haven't got it try programming it as a VCR - steps 1 through 6 above and substitute VCR for AUX.. Good Luck Bill

I found the code! It is 0736. The company is now called AudioLogic.

Have you used this DVD before in this player? Does it work in another player. Im thinking if it is new maybe its in the wrong format to use with your TV set.