How do you refill your bobbin - Necchi 4595 Mechanical Sewing Machine

You may have overfilled the Bobbin.....A little force will be required to remove it......I recommend using metal Bobbins......Do not fill the Bobbin outside of the Bobbin Rim...........

Owner's manual is the best source.

Nelco Sewing Machine Manuals Instruction and Repair Manuals

http://www.sewusa.com/Sewing_Machine_Manuals/Nelco_Sewing_Machines.htm

Nelco Sewing Machine Manual PDF and CD


P.S.--for ~$35, a standalone bobbin winder can be purchased at JoAnn's Hancocks, or Amazon.com.

...

Sorry... hate to say it but modern home singers are $%#&*@.

Have you tried a new bobbin? If the "spindle" spins... the bobbin should spin. Maybe your bobbin is busted or something?

then there is something wrong with the bobbin winder & it needs to be repaired

Check for correct bottom thread tension.
It's provided by a flat spring on the bobbin holder.
When the bobbin is correctly installed, pulling on the thread
should meet with slight resistance, and the bobbin should spin without
trying to jump out of the bobbin holder.

I've lost the manual to the Singer Tiny Tailor mending machine M100A and need to know how to refill the bobbins. Can you help me?

I was wrong. I thought there was something wrong with the top part of machine because I kept hearing a noise when I step on the pedal. Turns out the problem was on the bottom. The little part where the bobbin goes it has two little circular thingies that were not aligned correctly. Once I corrected this the machine works perfect again.

Nope it has a bobbin. Albeit a big bobbin sometimes. If it fed off a cone it would be chain stitch machine.

Normal 0 MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman";} To wind a bobbin, guide the thread from the spool post to the small round tensioner /guide on the top of the machine.Wind a few turns of thread onton the bobbin.Place the bobbin on the bobbin winder post. Release the hand wheel and wind the bobbin as full as you like or until it stops. Remove the bobbin,place it in the bobbin case and insert the bobbincase into the hook.

Beginning with the spool, guide the thread through the thread guides to the tension assembly. Pull the thread through the tension assembly and test it to make sure the tension is working correctly.
(To do this test, adjust your tension setting to normal or medium or 5 or something in the middle. Raise the presser foot and pull the thread through the tension. It should pull easily!! Lower the presser foot and pull the thread. It should pull noticeably harder.) If it passes this test, continue up through the take up lever,then down through the thread guides to the needle. Make sure your needle is fully inserted and turned the correct way.( If you load your bobbin case from the left side,the needle rule is normally FLAT to the RIGHT is RIGHT. There are some exceptions. If you have a newer style drop in bobbin or your bobbin case loads in the front then the rule is FLAT to the BACK.
sewman7